From: mani@kernel.org
To: gregkh@linuxfoundation.org
Cc: hemantk@codeaurora.org, jhugo@codeaurora.org,
linux-arm-msm@vger.kernel.org, linux-kernel@vger.kernel.org,
Bhaumik Bhatt <bbhatt@codeaurora.org>,
Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Subject: [PATCH 06/14] bus: mhi: core: Return appropriate error codes for AMSS load failure
Date: Thu, 21 May 2020 20:55:32 +0530 [thread overview]
Message-ID: <20200521152540.17335-7-mani@kernel.org> (raw)
In-Reply-To: <20200521152540.17335-1-mani@kernel.org>
From: Bhaumik Bhatt <bbhatt@codeaurora.org>
When loading AMSS firmware using BHIe protocol, return -ETIMEDOUT if no
response is received within the timeout or return -EIO in case of a
protocol returned failure or an MHI error state.
Signed-off-by: Bhaumik Bhatt <bbhatt@codeaurora.org>
Reviewed-by: Jeffrey Hugo <jhugo@codeaurora.org>
Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
---
drivers/bus/mhi/core/boot.c | 23 ++++++++++++-----------
1 file changed, 12 insertions(+), 11 deletions(-)
diff --git a/drivers/bus/mhi/core/boot.c b/drivers/bus/mhi/core/boot.c
index 17c636b4bc6e..cf6dc5a2361c 100644
--- a/drivers/bus/mhi/core/boot.c
+++ b/drivers/bus/mhi/core/boot.c
@@ -176,6 +176,7 @@ static int mhi_fw_load_amss(struct mhi_controller *mhi_cntrl,
void __iomem *base = mhi_cntrl->bhie;
rwlock_t *pm_lock = &mhi_cntrl->pm_lock;
u32 tx_status, sequence_id;
+ int ret;
read_lock_bh(pm_lock);
if (!MHI_REG_ACCESS_VALID(mhi_cntrl->pm_state)) {
@@ -198,19 +199,19 @@ static int mhi_fw_load_amss(struct mhi_controller *mhi_cntrl,
read_unlock_bh(pm_lock);
/* Wait for the image download to complete */
- wait_event_timeout(mhi_cntrl->state_event,
- MHI_PM_IN_ERROR_STATE(mhi_cntrl->pm_state) ||
- mhi_read_reg_field(mhi_cntrl, base,
- BHIE_TXVECSTATUS_OFFS,
- BHIE_TXVECSTATUS_STATUS_BMSK,
- BHIE_TXVECSTATUS_STATUS_SHFT,
- &tx_status) || tx_status,
- msecs_to_jiffies(mhi_cntrl->timeout_ms));
-
- if (MHI_PM_IN_ERROR_STATE(mhi_cntrl->pm_state))
+ ret = wait_event_timeout(mhi_cntrl->state_event,
+ MHI_PM_IN_ERROR_STATE(mhi_cntrl->pm_state) ||
+ mhi_read_reg_field(mhi_cntrl, base,
+ BHIE_TXVECSTATUS_OFFS,
+ BHIE_TXVECSTATUS_STATUS_BMSK,
+ BHIE_TXVECSTATUS_STATUS_SHFT,
+ &tx_status) || tx_status,
+ msecs_to_jiffies(mhi_cntrl->timeout_ms));
+ if (MHI_PM_IN_ERROR_STATE(mhi_cntrl->pm_state) ||
+ tx_status != BHIE_TXVECSTATUS_STATUS_XFER_COMPL)
return -EIO;
- return (tx_status == BHIE_TXVECSTATUS_STATUS_XFER_COMPL) ? 0 : -EIO;
+ return (!ret) ? -ETIMEDOUT : 0;
}
static int mhi_fw_load_sbl(struct mhi_controller *mhi_cntrl,
--
2.26.GIT
next prev parent reply other threads:[~2020-05-21 15:26 UTC|newest]
Thread overview: 17+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-05-21 15:25 [PATCH 00/14] MHI patches for v5.8 mani
2020-05-21 15:25 ` [PATCH 01/14] bus: mhi: core: Refactor mhi queue APIs mani
2020-05-21 15:25 ` [PATCH 02/14] bus: mhi: core: Cache intmod from mhi event to mhi channel mani
2020-05-21 15:25 ` [PATCH 03/14] bus: mhi: core: Add range check for channel id received in event ring mani
2020-05-21 15:25 ` [PATCH 04/14] bus: mhi: core: Read transfer length from an event properly mani
2020-05-21 15:25 ` [PATCH 05/14] bus: mhi: core: Handle firmware load using state worker mani
2020-05-21 15:25 ` mani [this message]
2020-05-21 15:25 ` [PATCH 07/14] bus: mhi: core: Improve debug logs for loading firmware mani
2020-05-21 15:25 ` [PATCH 08/14] bus: mhi: core: Ensure non-zero session or sequence ID values are used mani
2020-05-21 15:25 ` [PATCH 09/14] bus: mhi: core: Remove the system error worker thread mani
2020-05-21 15:25 ` [PATCH 10/14] bus: mhi: core: Handle disable transitions in state worker mani
2020-05-21 15:25 ` [PATCH 11/14] bus: mhi: core: Skip handling BHI irq if MHI reg access is not allowed mani
2020-05-21 15:25 ` [PATCH 12/14] bus: mhi: core: Do not process SYS_ERROR if RDDM is supported mani
2020-05-21 15:25 ` [PATCH 13/14] bus: mhi: core: Handle write lock properly in mhi_pm_m0_transition mani
2020-05-21 15:25 ` [PATCH 14/14] bus: mhi: core: Handle syserr during power_up mani
2020-05-21 15:29 ` [PATCH 00/14] MHI patches for v5.8 Manivannan Sadhasivam
2020-05-21 16:19 ` Greg KH
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200521152540.17335-7-mani@kernel.org \
--to=mani@kernel.org \
--cc=bbhatt@codeaurora.org \
--cc=gregkh@linuxfoundation.org \
--cc=hemantk@codeaurora.org \
--cc=jhugo@codeaurora.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=manivannan.sadhasivam@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.