Re: [PATCH 1/3] arm64: dts: qcom: pm8009: Add base dts file

[Bjorn Andersson <bjorn.andersson@linaro.org>]

On Sun 21 Jun 12:28 PDT 2020, Dmitry Baryshkov wrote:

> Add base DTS file for pm8009 along with GPIOs and power-on nodes.
> 
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>

I took the liberty of adding a pm8009_pon label to the pon node, then
applied the three patches.

Thanks,
Bjorn

> ---
>  arch/arm64/boot/dts/qcom/pm8009.dtsi | 37 ++++++++++++++++++++++++++++
>  1 file changed, 37 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/qcom/pm8009.dtsi
> 
> diff --git a/arch/arm64/boot/dts/qcom/pm8009.dtsi b/arch/arm64/boot/dts/qcom/pm8009.dtsi
> new file mode 100644
> index 000000000000..cb1a10e72474
> --- /dev/null
> +++ b/arch/arm64/boot/dts/qcom/pm8009.dtsi
> @@ -0,0 +1,37 @@
> +// SPDX-License-Identifier: BSD-3-Clause
> +/*
> + * Copyright (c) 2017-2019, The Linux Foundation. All rights reserved.
> + * Copyright (c) 2020, Linaro Limited
> + */
> +
> +#include <dt-bindings/spmi/spmi.h>
> +
> +&spmi_bus {
> +	pmic@a {
> +		compatible = "qcom,pm8009", "qcom,spmi-pmic";
> +		reg = <0xa SPMI_USID>;
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +
> +		pon@800 {
> +			compatible = "qcom,pm8916-pon";
> +			reg = <0x0800>;
> +		};
> +
> +		pm8009_gpios: gpio@c000 {
> +			compatible = "qcom,pm8005-gpio";
> +			reg = <0xc000>;
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +			interrupt-controller;
> +			#interrupt-cells = <2>;
> +		};
> +	};
> +
> +	pmic@b {
> +		compatible = "qcom,pm8009", "qcom,spmi-pmic";
> +		reg = <0xb SPMI_USID>;
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +	};
> +};
> -- 
> 2.27.0
>