[PATCH] ARM: dts: imx6qdl-gw54xx: allow boot firmware to set eth1 MAC

[PATCH] ARM: dts: imx6qdl-gw54xx: allow boot firmware to set eth1 MAC

[Tim Harvey]

The GW54xx has a PCIe based GbE as the 2nd ethernet device. The
boot firmware will populate the local-mac-address field of the
device aliased to ethernet1 thus adding the PCIe device to
dt allows boot firmware to set its MAC address.

Signed-off-by: Tim Harvey <tharvey@gateworks.com>
---
 arch/arm/boot/dts/imx6qdl-gw54xx.dtsi | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)

diff --git a/arch/arm/boot/dts/imx6qdl-gw54xx.dtsi b/arch/arm/boot/dts/imx6qdl-gw54xx.dtsi
index c40583d..5527f95 100644
--- a/arch/arm/boot/dts/imx6qdl-gw54xx.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-gw54xx.dtsi
@@ -9,6 +9,7 @@
 / {
 	/* these are used by bootloader for disabling nodes */
 	aliases {
+		ethernet1 = &eth1;
 		led0 = &led0;
 		led1 = &led1;
 		led2 = &led2;
@@ -398,6 +399,23 @@
 	pinctrl-0 = <&pinctrl_pcie>;
 	reset-gpio = <&gpio1 29 GPIO_ACTIVE_LOW>;
 	status = "okay";
+
+	pcie@0,0,0 {
+		reg = <0x0000 0 0 0 0>;
+
+		pcie@1,0,0 {
+			reg = <0x0000 0 0 0 0>;
+
+			pcie@2,8,0 {
+				reg = <0x4000 0 0 0 0>;
+
+				eth1: pcie@8,0,0 {
+					reg = <0x0000 0 0 0 0>;
+					local-mac-address = [00 00 00 00 00 00];
+				};
+			};
+		};
+	};
 };
 
 &pwm1 {
-- 
2.7.4


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

[PATCH] ARM: dts: imx6qdl-gw54xx: allow boot firmware to set eth1 MAC

[Tim Harvey]

The GW54xx has a PCIe based GbE as the 2nd ethernet device. The
boot firmware will populate the local-mac-address field of the
device aliased to ethernet1 thus adding the PCIe device to
dt allows boot firmware to set its MAC address.

Signed-off-by: Tim Harvey <tharvey@gateworks.com>
---
 arch/arm/boot/dts/imx6qdl-gw54xx.dtsi | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)

diff --git a/arch/arm/boot/dts/imx6qdl-gw54xx.dtsi b/arch/arm/boot/dts/imx6qdl-gw54xx.dtsi
index c40583d..5527f95 100644
--- a/arch/arm/boot/dts/imx6qdl-gw54xx.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-gw54xx.dtsi
@@ -9,6 +9,7 @@
 / {
 	/* these are used by bootloader for disabling nodes */
 	aliases {
+		ethernet1 = &eth1;
 		led0 = &led0;
 		led1 = &led1;
 		led2 = &led2;
@@ -398,6 +399,23 @@
 	pinctrl-0 = <&pinctrl_pcie>;
 	reset-gpio = <&gpio1 29 GPIO_ACTIVE_LOW>;
 	status = "okay";
+
+	pcie@0,0,0 {
+		reg = <0x0000 0 0 0 0>;
+
+		pcie@1,0,0 {
+			reg = <0x0000 0 0 0 0>;
+
+			pcie@2,8,0 {
+				reg = <0x4000 0 0 0 0>;
+
+				eth1: pcie@8,0,0 {
+					reg = <0x0000 0 0 0 0>;
+					local-mac-address = [00 00 00 00 00 00];
+				};
+			};
+		};
+	};
 };
 
 &pwm1 {
-- 
2.7.4

Re: [PATCH] ARM: dts: imx6qdl-gw54xx: allow boot firmware to set eth1 MAC

[Shawn Guo]

On Thu, May 28, 2020 at 12:53:16PM -0700, Tim Harvey wrote:
> The GW54xx has a PCIe based GbE as the 2nd ethernet device. The
> boot firmware will populate the local-mac-address field of the
> device aliased to ethernet1 thus adding the PCIe device to
> dt allows boot firmware to set its MAC address.
> 
> Signed-off-by: Tim Harvey <tharvey@gateworks.com>

Applied, thanks.