[PATCH] habanalabs: increase h/w timer when checking idle

[PATCH] habanalabs: increase h/w timer when checking idle

[Oded Gabbay]

From: Omer Shpigelman <oshpigelman@habana.ai>

In GAUDI the current timer value for the hardware to check if it is
in IDLE state is too low. As a result, there are occasions where the H/W
wrongly reports it is not IDLE. The driver checks that before submitting
work on behalf of the driver during initialization, so a false report might
cause the driver to fail during device initialization.

Signed-off-by: Omer Shpigelman <oshpigelman@habana.ai>
Signed-off-by: Oded Gabbay <oded.gabbay@gmail.com>
---
 drivers/misc/habanalabs/gaudi/gaudi.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/misc/habanalabs/gaudi/gaudi.c b/drivers/misc/habanalabs/gaudi/gaudi.c
index 69317d2ebdfa..834470d10b46 100644
--- a/drivers/misc/habanalabs/gaudi/gaudi.c
+++ b/drivers/misc/habanalabs/gaudi/gaudi.c
@@ -1893,6 +1893,8 @@ static void gaudi_init_pci_dma_qman(struct hl_device *hdev, int dma_id,
 	WREG32(mmDMA0_QM_CP_MSG_BASE3_ADDR_LO_0 + q_off, so_base_ws_lo);
 	WREG32(mmDMA0_QM_CP_MSG_BASE3_ADDR_HI_0 + q_off, so_base_ws_hi);
 
+	WREG32(mmDMA0_QM_CP_BARRIER_CFG_0 + q_off, 0x100);
+
 	/* The following configuration is needed only once per QMAN */
 	if (qman_id == 0) {
 		/* Configure RAZWI IRQ */
-- 
2.17.1