[PATCH 06/20] ata: pata_amd: Remove superfluous, add missing and fix broken params

[Lee Jones <lee.jones@linaro.org>]

Fixes the following W=1 kernel build warning(s):

 drivers/ata/pata_amd.c:179: warning: Excess function parameter 'adev' description in 'amd_fifo_setup'
 drivers/ata/pata_amd.c:331: warning: Function parameter or member 'link' not described in 'nv_pre_reset'
 drivers/ata/pata_amd.c:331: warning: Function parameter or member 'deadline' not described in 'nv_pre_reset'
 drivers/ata/pata_amd.c:331: warning: expecting prototype for nv_probe_init(). Prototype was for nv_pre_reset() instead

Cc: Jens Axboe <axboe@kernel.dk>
Cc: linux-ide@vger.kernel.org
Signed-off-by: Lee Jones <lee.jones@linaro.org>
---
 drivers/ata/pata_amd.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/ata/pata_amd.c b/drivers/ata/pata_amd.c
index 987967f976cb2..75b830eb3c542 100644
--- a/drivers/ata/pata_amd.c
+++ b/drivers/ata/pata_amd.c
@@ -167,7 +167,6 @@ static int amd_cable_detect(struct ata_port *ap)
 /**
  *	amd_fifo_setup		-	set the PIO FIFO for ATA/ATAPI
  *	@ap: ATA interface
- *	@adev: ATA device
  *
  *	Set the PCI fifo for this device according to the devices present
  *	on the bus at this point in time. We need to turn the post write buffer
@@ -321,7 +320,8 @@ static unsigned long nv_mode_filter(struct ata_device *dev,
 
 /**
  *	nv_probe_init	-	cable detection
- *	@lin: ATA link
+ *	@link: ATA link
+ *	@deadline: deadline jiffies for the operation
  *
  *	Perform cable detection. The BIOS stores this in PCI config
  *	space for us.
-- 
2.25.1