[bug report] spi: pxa2xx: Reuse int_stop_and_reset() in couple of places

[Dan Carpenter <dan.carpenter@oracle.com>]

Hello Andy Shevchenko,

The patch 3bbdc083262d: "spi: pxa2xx: Reuse int_stop_and_reset() in
couple of places" from Jul 19, 2021, leads to the following static
checker warning:

	drivers/spi/spi-pxa2xx.c:774 ssp_int()
	error: we previously assumed 'drv_data->controller->cur_msg' could be null (see line 773)

drivers/spi/spi-pxa2xx.c
    731 static irqreturn_t ssp_int(int irq, void *dev_id)
    732 {
    733 	struct driver_data *drv_data = dev_id;
    734 	u32 sccr1_reg;
    735 	u32 mask = drv_data->mask_sr;
    736 	u32 status;
    737 
    738 	/*
    739 	 * The IRQ might be shared with other peripherals so we must first
    740 	 * check that are we RPM suspended or not. If we are we assume that
    741 	 * the IRQ was not for us (we shouldn't be RPM suspended when the
    742 	 * interrupt is enabled).
    743 	 */
    744 	if (pm_runtime_suspended(drv_data->ssp->dev))
    745 		return IRQ_NONE;
    746 
    747 	/*
    748 	 * If the device is not yet in RPM suspended state and we get an
    749 	 * interrupt that is meant for another device, check if status bits
    750 	 * are all set to one. That means that the device is already
    751 	 * powered off.
    752 	 */
    753 	status = pxa2xx_spi_read(drv_data, SSSR);
    754 	if (status == ~0)
    755 		return IRQ_NONE;
    756 
    757 	sccr1_reg = pxa2xx_spi_read(drv_data, SSCR1);
    758 
    759 	/* Ignore possible writes if we don't need to write */
    760 	if (!(sccr1_reg & SSCR1_TIE))
    761 		mask &= ~SSSR_TFS;
    762 
    763 	/* Ignore RX timeout interrupt if it is disabled */
    764 	if (!(sccr1_reg & SSCR1_TINTE))
    765 		mask &= ~SSSR_TINT;
    766 
    767 	if (!(status & mask))
    768 		return IRQ_NONE;
    769 
    770 	pxa2xx_spi_write(drv_data, SSCR1, sccr1_reg & ~drv_data->int_cr1);
    771 	pxa2xx_spi_write(drv_data, SSCR1, sccr1_reg);
    772 
    773 	if (!drv_data->controller->cur_msg) {
--> 774 		handle_bad_msg(drv_data);
                        ^^^^^^^^^^^^^^^^^^^^^^^^
We can't reset with a NULL drv_data->controller->cur_msg.

    775 		/* Never fail */
    776 		return IRQ_HANDLED;
    777 	}
    778 
    779 	return drv_data->transfer_handler(drv_data);
    780 }

regards,
dan carpenter