Re: [PATCH v2 1/8] PCI: rcar-gen2: Add support for clocks

[Herve Codina <herve.codina@bootlin.com>]

Hi Geert,

On Thu, 14 Apr 2022 13:48:22 +0200
Geert Uytterhoeven <geert@linux-m68k.org> wrote:

> Hi Hervé,
> 
> On Thu, Apr 14, 2022 at 1:29 PM Herve Codina <herve.codina@bootlin.com> wrote:
> > On Thu, 14 Apr 2022 10:45:54 +0200
> > Geert Uytterhoeven <geert@linux-m68k.org> wrote:  
> > > On Thu, Apr 14, 2022 at 9:40 AM Herve Codina <herve.codina@bootlin.com> wrote:  
> > > > The PCI rcar-gen2 does not call any clk_prepare_enable().  
> > >
> > > Correct, this driver manages the clocks indirectly through Runtime PM.
> > >  
> > > > This lead to an access failure when the driver tries to access
> > > > the IP (at least on a RZ/N1D platform).  
> > >
> > > I expect adding
> > >
> > >     power-domans = <&sysctrl>;
> > >
> > > to the pci_usb node makes this patch redundant.  
> >
> > Seems not enough.
> > I tried what you suggest :
> >  - Added 'power-domains = <&systrl>;' to the pci_usb node
> >  - Added missing '#power-domain-cells = <0>;' to sysctrl node
> >  - Reverted my patch.
> >
> > The system crashed at boot:  
> 
> > [    0.832958] Unhandled fault: external abort on non-linefetch (0x1008) at 0x90b5f848  
> 
> That's indeed a typical symptom of accessing a module's registers
> while the module's clock is disabled.
> 
> > I also added a trace printk in r9a06g032-clocks.c and
> > r9a06g032_attach_dev() was never called.
> >
> > Did I miss to set something ?  
> 
> Do you have CONFIG_PM and CONFIG_PM_GENERIC_DOMAINS
> enabled?
> Apparently ARCH_RZN1 does not select these options yet.
> 

Thanks a lot for pointing this.

I added select CONFIG_PM and CONFIG_PM_GENERIC_DOMAINS
in ARCH_RZN1 and it works.

I will remove my patch calling clk_bulk_prepare_enable() and
add some new patches to enable power domains in the v3 series.

Regards,
Hervé