Re: [PATCH v2 0/2] iio: humidity: si7020: Check device property for skipping reset in probe

[Jonathan Cameron <Jonathan.Cameron@Huawei.com>]

On Thu, 12 May 2022 11:20:18 -0500
Eddie James <eajames@linux.ibm.com> wrote:

> I2C commands issued after the SI7020 is starting up or after reset
> can potentially upset the startup sequence. Therefore, the host
> needs to wait for the startup sequence to finish before issuing
> further i2c commands. This is impractical in cases where the SI7020
> is on a shared bus or behind a mux, which may switch channels at
> any time (generating I2C traffic). Therefore, check for a device
> property that indicates that the driver should skip resetting the
> device when probing.

Why not lock the bus?  It's not ideal, but then not resetting and hence
potentially ending up in an unknown state isn't great either.

Jonathan

> 
> Changes since v1:
>  - Fix dt binding document
> 
> Eddie James (2):
>   dt-bindings: iio: humidity: Add si7020 bindings
>   iio: humidity: si7020: Check device property for skipping reset in probe
> 
>  .../bindings/iio/humidity/silabs,si7020.yaml  | 47 +++++++++++++++++++
>  .../devicetree/bindings/trivial-devices.yaml  |  2 -
>  drivers/iio/humidity/si7020.c                 | 14 +++---
>  3 files changed, 55 insertions(+), 8 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/iio/humidity/silabs,si7020.yaml
>