[PATCH 08/11] i2c: designware: Move debug print in i2c_dw_isr()

[Jarkko Nikula <jarkko.nikula@linux.intel.com>]

It is kind of needless to print interrupt status when code immediately
after that finds interrupt was not originating from this device.
Therefore move it after spurious interrupt detection.

Signed-off-by: Jarkko Nikula <jarkko.nikula@linux.intel.com>
---
 drivers/i2c/busses/i2c-designware-master.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/i2c/busses/i2c-designware-master.c b/drivers/i2c/busses/i2c-designware-master.c
index dce74f8ab171..46e0e6a05506 100644
--- a/drivers/i2c/busses/i2c-designware-master.c
+++ b/drivers/i2c/busses/i2c-designware-master.c
@@ -775,11 +775,11 @@ static irqreturn_t i2c_dw_isr(int this_irq, void *dev_id)
 
 	regmap_read(dev->map, DW_IC_ENABLE, &enabled);
 	regmap_read(dev->map, DW_IC_RAW_INTR_STAT, &stat);
-	dev_dbg(dev->dev, "enabled=%#x stat=%#x\n", enabled, stat);
 	if (!enabled || !(stat & ~DW_IC_INTR_ACTIVITY))
 		return IRQ_NONE;
 	if (pm_runtime_suspended(dev->dev) || stat == ~0)
 		return IRQ_NONE;
+	dev_dbg(dev->dev, "enabled=%#x stat=%#x\n", enabled, stat);
 
 	i2c_dw_irq_handler_master(dev);
 
-- 
2.35.1