Re: [PATCH v4 18/18] PCI: j721e: Add suspend and resume support

[Bjorn Helgaas <helgaas@kernel.org>]

On Mon, Mar 04, 2024 at 04:36:01PM +0100, Thomas Richard wrote:
> From: Théo Lebrun <theo.lebrun@bootlin.com>
> 
> Add suspend and resume support. Only the rc mode is supported.
> 
> During the suspend stage PERST# is asserted, then deasserted during the
> resume stage.

> +		 * "Power Sequencing and Reset Signal Timings" table in
> +		 * PCI EXPRESS CARD ELECTROMECHANICAL SPECIFICATION, REV. 3.0
> +		 * indicates PERST# should be deasserted after minimum of 100us
> +		 * once REFCLK is stable. The REFCLK to the connector in RC
> +		 * mode is selected while enabling the PHY. So deassert PERST#
> +		 * after 100 us.

Please cite current spec (r5.1 was published August 2023), section,
and parameter name.  I think this is T_PERST-CLK, "REFCLK stable
before PERST# inactive", from sec 2.9.2.

> +		 */
> +		if (pcie->reset_gpio) {
> +			fsleep(100);

I'd like to see a macro used here instead of a bare number.  Since
this isn't anything specific to j721e, maybe add something like
#define PCIE_T_PERST_CLK_US alongside PCIE_T_PVPERL_MS.

> +			gpiod_set_value_cansleep(pcie->reset_gpio, 1);
> +		}