[PATCH] config: imx: Add PHYTEC's phycore-imx8mm-fspi_defconfig

[Lukasz Majewski <lukma@denx.de>]

This configuration file provides support for booting phycore module
(on e.g. polis-rdk base development board) from QSPI memory.

Moreover, the SDP SPL gadget is supported, so single flash.bin
binary can be used with uuu (with uuu -v -b qspi ~/u-boot/flash.bin)
to flash QSPI in the factory or during debricking.

Signed-off-by: Lukasz Majewski <lukma@denx.de>
---
 configs/phycore-imx8mm-fspi_defconfig | 158 ++++++++++++++++++++++++++
 1 file changed, 158 insertions(+)
 create mode 100644 configs/phycore-imx8mm-fspi_defconfig

diff --git a/configs/phycore-imx8mm-fspi_defconfig b/configs/phycore-imx8mm-fspi_defconfig
new file mode 100644
index 0000000000..79a2668254
--- /dev/null
+++ b/configs/phycore-imx8mm-fspi_defconfig
@@ -0,0 +1,158 @@
+CONFIG_ARM=y
+CONFIG_ARCH_IMX8M=y
+CONFIG_TEXT_BASE=0x40200000
+CONFIG_SYS_MALLOC_LEN=0x2000000
+CONFIG_SPL_GPIO=y
+CONFIG_SPL_LIBCOMMON_SUPPORT=y
+CONFIG_SPL_LIBGENERIC_SUPPORT=y
+CONFIG_SF_DEFAULT_SPEED=80000000
+CONFIG_ENV_SIZE=0x10000
+CONFIG_ENV_OFFSET=0x3C0000
+CONFIG_IMX_CONFIG="board/freescale/imx8mm_evk/imximage-8mm-lpddr4-fspi.cfg"
+CONFIG_DM_GPIO=y
+CONFIG_DEFAULT_DEVICE_TREE="freescale/imx8mm-phyboard-polis-rdk"
+CONFIG_SPL_TEXT_BASE=0x7E2000
+CONFIG_TARGET_PHYCORE_IMX8MM=y
+CONFIG_DM_RESET=y
+CONFIG_SYS_MONITOR_LEN=524288
+CONFIG_SPL_MMC=y
+CONFIG_SPL_SERIAL=y
+CONFIG_SPL_DRIVERS_MISC=y
+CONFIG_SPL_STACK=0x920000
+CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
+CONFIG_SPL_BSS_START_ADDR=0x910000
+CONFIG_SPL_BSS_MAX_SIZE=0x2000
+CONFIG_SPL=y
+CONFIG_ENV_OFFSET_REDUND=0x3E0000
+CONFIG_SYS_LOAD_ADDR=0x40480000
+CONFIG_PCI=y
+# CONFIG_ANDROID_BOOT_IMAGE is not set
+CONFIG_FIT=y
+CONFIG_FIT_EXTERNAL_OFFSET=0x3000
+CONFIG_SPL_LOAD_FIT=y
+CONFIG_OF_SYSTEM_SETUP=y
+CONFIG_USE_BOOTCOMMAND=y
+CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then if run loadimage; then run mmcboot; else run netboot; fi; fi;"
+CONFIG_DEFAULT_FDT_FILE="oftree"
+CONFIG_SYS_CBSIZE=2048
+CONFIG_SYS_PBSIZE=2074
+CONFIG_BOARD_LATE_INIT=y
+CONFIG_SPL_MAX_SIZE=0x25000
+CONFIG_SPL_PAD_TO=0x0
+# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
+CONFIG_SPL_SYS_MALLOC=y
+CONFIG_SPL_HAS_CUSTOM_MALLOC_START=y
+CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x42200000
+CONFIG_SPL_SYS_MALLOC_SIZE=0x80000
+CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
+CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x300
+CONFIG_SPL_I2C=y
+CONFIG_SPL_NOR_SUPPORT=y
+CONFIG_SPL_POWER=y
+CONFIG_SPL_SPI_FLASH_MTD=y
+CONFIG_SPL_WATCHDOG=y
+CONFIG_HUSH_PARSER=y
+CONFIG_SYS_PROMPT="u-boot=> "
+# CONFIG_CMD_EXPORTENV is not set
+# CONFIG_CMD_IMPORTENV is not set
+# CONFIG_CMD_CRC32 is not set
+CONFIG_CMD_EEPROM=y
+CONFIG_SYS_I2C_EEPROM_ADDR_LEN=2
+CONFIG_SYS_EEPROM_SIZE=4096
+CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=5
+CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
+CONFIG_CMD_CLK=y
+CONFIG_CMD_FUSE=y
+CONFIG_CMD_GPIO=y
+CONFIG_CMD_I2C=y
+CONFIG_CMD_MMC=y
+CONFIG_CMD_PCI=y
+CONFIG_CMD_SF_TEST=y
+CONFIG_CMD_DHCP=y
+CONFIG_CMD_MII=y
+CONFIG_CMD_PING=y
+CONFIG_CMD_CACHE=y
+CONFIG_CMD_REGULATOR=y
+CONFIG_CMD_EXT2=y
+CONFIG_CMD_EXT4=y
+CONFIG_CMD_EXT4_WRITE=y
+CONFIG_CMD_FAT=y
+CONFIG_OF_CONTROL=y
+CONFIG_SPL_OF_CONTROL=y
+CONFIG_ENV_OVERWRITE=y
+CONFIG_ENV_IS_IN_MMC=y
+CONFIG_SYS_REDUNDAND_ENVIRONMENT=y
+CONFIG_SYS_RELOC_GD_ENV_ADDR=y
+CONFIG_SYS_MMC_ENV_DEV=2
+CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG=y
+CONFIG_SPL_DM=y
+CONFIG_SPL_CLK_COMPOSITE_CCF=y
+CONFIG_CLK_COMPOSITE_CCF=y
+CONFIG_SPL_CLK_IMX8MM=y
+CONFIG_CLK_IMX8MM=y
+CONFIG_USB_FUNCTION_FASTBOOT=y
+CONFIG_FASTBOOT_BUF_ADDR=0x42800000
+CONFIG_FASTBOOT_UUU_SUPPORT=y
+CONFIG_MXC_GPIO=y
+CONFIG_DM_I2C=y
+CONFIG_MISC=y
+CONFIG_I2C_EEPROM=y
+CONFIG_SYS_I2C_EEPROM_ADDR=0x51
+CONFIG_SUPPORT_EMMC_BOOT=y
+CONFIG_MMC_IO_VOLTAGE=y
+CONFIG_MMC_UHS_SUPPORT=y
+CONFIG_MMC_HS400_ES_SUPPORT=y
+CONFIG_MMC_HS400_SUPPORT=y
+CONFIG_FSL_USDHC=y
+CONFIG_MTD=y
+CONFIG_DM_MTD=y
+CONFIG_DM_SPI_FLASH=y
+CONFIG_SF_DEFAULT_BUS=3
+CONFIG_SPI_FLASH_BAR=y
+CONFIG_SPI_FLASH_MACRONIX=y
+CONFIG_SPI_FLASH_SPANSION=y
+CONFIG_SPI_FLASH_STMICRO=y
+CONFIG_SPI_FLASH_SST=y
+CONFIG_SPI_FLASH_WINBOND=y
+# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
+CONFIG_SPI_FLASH_MTD=y
+CONFIG_PHYLIB=y
+CONFIG_PHY_TI_DP83867=y
+CONFIG_PHY_GIGE=y
+CONFIG_FEC_MXC=y
+CONFIG_MII=y
+CONFIG_NVME_PCI=y
+CONFIG_PCIE_DW_IMX=y
+CONFIG_PHY_IMX8M_PCIE=y
+CONFIG_PINCTRL=y
+CONFIG_SPL_PINCTRL=y
+CONFIG_PINCTRL_IMX8M=y
+CONFIG_POWER_DOMAIN=y
+CONFIG_IMX8M_POWER_DOMAIN=y
+CONFIG_DM_REGULATOR_FIXED=y
+CONFIG_DM_REGULATOR_GPIO=y
+CONFIG_DM_SERIAL=y
+CONFIG_MXC_UART=y
+CONFIG_SPI=y
+CONFIG_DM_SPI=y
+CONFIG_NXP_FSPI=y
+CONFIG_SYSRESET=y
+CONFIG_SPL_SYSRESET=y
+CONFIG_SYSRESET_PSCI=y
+CONFIG_SYSRESET_WATCHDOG=y
+CONFIG_DM_THERMAL=y
+CONFIG_IMX_TMU=y
+CONFIG_USB=y
+CONFIG_SPL_USB_HOST=y
+CONFIG_USB_EHCI_HCD=y
+CONFIG_MXC_USB_OTG_HACTIVE=y
+CONFIG_USB_GADGET=y
+CONFIG_SPL_USB_GADGET=y
+CONFIG_USB_GADGET_VENDOR_NUM=0x0525
+CONFIG_USB_GADGET_PRODUCT_NUM=0xa4a5
+CONFIG_CI_UDC=y
+CONFIG_SDP_LOADADDR=0x40400000
+CONFIG_SPL_USB_SDP_SUPPORT=y
+CONFIG_IMX_WATCHDOG=y
+CONFIG_FSPI_CONF_HEADER=y
+CONFIG_FSPI_CONF_FILE="fspi_header.bin"
-- 
2.39.2