[PATCH 04/15] iio: common: st: use irq_get_trigger_type()

[Jonathan Cameron <jic23@kernel.org>]

From: Jonathan Cameron <Jonathan.Cameron@huawei.com>

Use irq_get_trigger_type() to replace getting the irq data then the
type in two steps.

Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
---
 drivers/iio/common/st_sensors/st_sensors_trigger.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/iio/common/st_sensors/st_sensors_trigger.c b/drivers/iio/common/st_sensors/st_sensors_trigger.c
index a0df9250a69f..1c51ac110078 100644
--- a/drivers/iio/common/st_sensors/st_sensors_trigger.c
+++ b/drivers/iio/common/st_sensors/st_sensors_trigger.c
@@ -134,7 +134,7 @@ int st_sensors_allocate_trigger(struct iio_dev *indio_dev,
 	iio_trigger_set_drvdata(sdata->trig, indio_dev);
 	sdata->trig->ops = trigger_ops;
 
-	irq_trig = irqd_get_trigger_type(irq_get_irq_data(sdata->irq));
+	irq_trig = irq_get_trigger_type(sdata->irq);
 	/*
 	 * If the IRQ is triggered on falling edge, we need to mark the
 	 * interrupt as active low, if the hardware supports this.
-- 
2.46.0