Re: [PATCH net-next v3 0/5] Add Ethernet MAC support for SpacemiT K1

[Simon Horman <horms@kernel.org>]

On Wed, Jul 02, 2025 at 02:01:39PM +0800, Vivian Wang wrote:
> SpacemiT K1 has two gigabit Ethernet MACs with RGMII and RMII support.
> Add a driver for them, as well as the supporting devicetree and bindings
> updates.
> 
> Tested on BananaPi BPI-F3 and Milk-V Jupiter.
> 
> I would like to note that even though some bit field names superficially
> resemble that of DesignWare MAC, all other differences point to it in
> fact being a custom design.
> 
> Based on SpacemiT drivers [1].
> 
> This series depends on reset controller support [2] and DMA buses [3]
> for K1. There are some minor conflicts resulting from both touching
> k1.dtsi, but it should just both be adding nodes.
> 
> These patches can also be pulled from:
> 
> https://github.com/dramforever/linux/tree/k1/ethernet/v3
> 
> [1]: https://github.com/spacemit-com/linux-k1x
> [2]: https://lore.kernel.org/all/20250613011139.1201702-1-elder@riscstar.com
> [3]: https://lore.kernel.org/all/20250623-k1-dma-buses-rfc-wip-v1-0-c0144082061f@iscas.ac.cn
> 
> ---
> Changes in v3:
> - Refactored and simplified emac_tx_mem_map
> - Addressed other minor v2 review comments
> - Removed what was patch 3 in v2, depend on DMA buses instead
> - DT nodes in alphabetical order where appropriate
> - Link to v2: https://lore.kernel.org/r/20250618-net-k1-emac-v2-0-94f5f07227a8@iscas.ac.cn
> 
> Changes in v2:
> - dts: Put eth0 and eth1 nodes under a bus with dma-ranges
> - dts: Added Milk-V Jupiter
> - Fix typo in emac_init_hw() that broke the driver (Oops!)
> - Reformatted line lengths to under 80
> - Addressed other v1 review comments
> - Link to v1: https://lore.kernel.org/r/20250613-net-k1-emac-v1-0-cc6f9e510667@iscas.ac.cn
> 
> ---
> Vivian Wang (5):
>       dt-bindings: net: Add support for SpacemiT K1
>       net: spacemit: Add K1 Ethernet MAC
>       riscv: dts: spacemit: Add Ethernet support for K1
>       riscv: dts: spacemit: Add Ethernet support for BPI-F3
>       riscv: dts: spacemit: Add Ethernet support for Jupiter

I'm unsure on the plan for merging this.  But it seems to me that the first
two patches ought to go though net-next. But in order for patches to
proceed through net-next the entire series ought to apply on that tree - so
CI can run.

I'm not sure on the way forward.  But perhaps splitting the series in two:
the first two patches for net-next; and, the riscv patches targeted elsewhere
makes sense?

</2c>

_______________________________________________
linux-riscv mailing list
linux-riscv@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-riscv