[PATCH v3 0/2] riscv: dts: starfive: Add OrangePi RV board

[E Shattow <e@freeshell.de>]

Icenowy is busy and so with their permission I have applied v2 review
feedback. Additionally I revise the commit messages. This should now be in
good shape for -next

- E

Changes since v2:
- enable active high mmc1 card detect gpio
- drop delete-node from mmc0 reset pins following commit fa939a287224
  ("dts: starfive: jh7110-common: split out mmc0 reset pins from common 
  into boards")
- sort phy0 properties rx before tx
- revise commit description of SoC peripherals as list
- revise commit description of compatible binding

Changes in v2:
- Property order change mentioned in the review of v1.
- Added Wi-Fi (along with the always on VCC3V3_PCIE regulator, which is
  used to power up WIFI_3V3). The OOB IRQ is still not possible to use
  because of some incompatibility between StarFive pinctrl driver and
  brcmfmac.
- Removed the LED because it's in common DTSI.

Icenowy Zheng (2):
  dt-bindings: riscv: starfive: add xunlong,orangepi-rv
  riscv: dts: starfive: add Orange Pi RV

 .../devicetree/bindings/riscv/starfive.yaml   |  1 +
 arch/riscv/boot/dts/starfive/Makefile         |  1 +
 .../boot/dts/starfive/jh7110-orangepi-rv.dts  | 76 +++++++++++++++++++
 3 files changed, 78 insertions(+)
 create mode 100644 arch/riscv/boot/dts/starfive/jh7110-orangepi-rv.dts


base-commit: 1088d49b626487777913079bef0db3adef4bfb4a
-- 
2.50.0


_______________________________________________
linux-riscv mailing list
linux-riscv@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-riscv