All of lore.kernel.org
 help / color / mirror / Atom feed
From: Aurelien Jarno <aurelien@aurel32.net>
To: linux-kernel@vger.kernel.org, Rob Herring <robh@kernel.org>,
	Krzysztof Kozlowski <krzk+dt@kernel.org>,
	Conor Dooley <conor+dt@kernel.org>, Yixun Lan <dlan@kernel.org>,
	Paul Walmsley <pjw@kernel.org>,
	Palmer Dabbelt <palmer@dabbelt.com>,
	Albert Ou <aou@eecs.berkeley.edu>,
	Alexandre Ghiti <alex@ghiti.fr>
Cc: Aurelien Jarno <aurelien@aurel32.net>,
	devicetree@vger.kernel.org (open list:OPEN FIRMWARE AND
	FLATTENED DEVICE TREE BINDINGS),
	linux-riscv@lists.infradead.org (open list:RISC-V ARCHITECTURE),
	spacemit@lists.linux.dev (open list:RISC-V SPACEMIT SoC Support)
Subject: [PATCH 4/4] riscv: dts: spacemit: enable SD card support on Milk-V Jupiter
Date: Thu, 14 May 2026 17:56:24 +0200	[thread overview]
Message-ID: <20260514160356.1642075-5-aurelien@aurel32.net> (raw)
In-Reply-To: <20260514160356.1642075-1-aurelien@aurel32.net>

Add complete SD card controller support with UHS high-speed modes.

- Enable sdhci0 controller with 4-bit bus width
- Configure card detect GPIO with pull-up
- Connect vmmc-supply to buck4 for 3.3V card power
- Connect vqmmc-supply to aldo1 for 1.8V/3.3V I/O switching
- Add dual pinctrl states for voltage-dependent pin configuration
- Support UHS-I SDR25, SDR50, and SDR104 modes
- Alias it as mmc1

Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
---
 .../boot/dts/spacemit/k1-milkv-jupiter.dts    | 21 ++++++++++++++++++-
 1 file changed, 20 insertions(+), 1 deletion(-)

diff --git a/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts b/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts
index b9b8ddc8e7fb0..7cf77437e0c2d 100644
--- a/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts
+++ b/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts
@@ -18,6 +18,7 @@ aliases {
 		i2c2 = &i2c2;
 		i2c8 = &i2c8;
 		mmc0 = &emmc;
+		mmc1 = &sdhci0;
 		serial0 = &uart0;
 	};
 
@@ -282,7 +283,7 @@ buck6 {
 				regulator-always-on;
 			};
 
-			aldo1 {
+			aldo1: aldo1 {
 				regulator-min-microvolt = <500000>;
 				regulator-max-microvolt = <3400000>;
 				regulator-boot-on;
@@ -417,6 +418,24 @@ uboot@a00000 {
 	};
 };
 
+&sdhci0 {
+	pinctrl-names = "default", "uhs";
+	pinctrl-0 = <&mmc1_cfg>;
+	pinctrl-1 = <&mmc1_uhs_cfg>;
+	bus-width = <4>;
+	cd-gpios = <&gpio K1_GPIO(80) (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
+	no-mmc;
+	no-sdio;
+	disable-wp;
+	cap-sd-highspeed;
+	vmmc-supply = <&buck4_3v3>;
+	vqmmc-supply = <&aldo1>;
+	sd-uhs-sdr25;
+	sd-uhs-sdr50;
+	sd-uhs-sdr104;
+	status = "okay";
+};
+
 &uart0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart0_2_cfg>;
-- 
2.53.0


WARNING: multiple messages have this Message-ID (diff)
From: Aurelien Jarno <aurelien@aurel32.net>
To: linux-kernel@vger.kernel.org, Rob Herring <robh@kernel.org>,
	Krzysztof Kozlowski <krzk+dt@kernel.org>,
	Conor Dooley <conor+dt@kernel.org>, Yixun Lan <dlan@kernel.org>,
	Paul Walmsley <pjw@kernel.org>,
	Palmer Dabbelt <palmer@dabbelt.com>,
	Albert Ou <aou@eecs.berkeley.edu>,
	Alexandre Ghiti <alex@ghiti.fr>
Cc: Aurelien Jarno <aurelien@aurel32.net>,
	devicetree@vger.kernel.org (open list:OPEN FIRMWARE AND
	FLATTENED DEVICE TREE BINDINGS),
	linux-riscv@lists.infradead.org (open list:RISC-V ARCHITECTURE),
	spacemit@lists.linux.dev (open list:RISC-V SPACEMIT SoC Support)
Subject: [PATCH 4/4] riscv: dts: spacemit: enable SD card support on Milk-V Jupiter
Date: Thu, 14 May 2026 17:56:24 +0200	[thread overview]
Message-ID: <20260514160356.1642075-5-aurelien@aurel32.net> (raw)
In-Reply-To: <20260514160356.1642075-1-aurelien@aurel32.net>

Add complete SD card controller support with UHS high-speed modes.

- Enable sdhci0 controller with 4-bit bus width
- Configure card detect GPIO with pull-up
- Connect vmmc-supply to buck4 for 3.3V card power
- Connect vqmmc-supply to aldo1 for 1.8V/3.3V I/O switching
- Add dual pinctrl states for voltage-dependent pin configuration
- Support UHS-I SDR25, SDR50, and SDR104 modes
- Alias it as mmc1

Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
---
 .../boot/dts/spacemit/k1-milkv-jupiter.dts    | 21 ++++++++++++++++++-
 1 file changed, 20 insertions(+), 1 deletion(-)

diff --git a/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts b/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts
index b9b8ddc8e7fb0..7cf77437e0c2d 100644
--- a/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts
+++ b/arch/riscv/boot/dts/spacemit/k1-milkv-jupiter.dts
@@ -18,6 +18,7 @@ aliases {
 		i2c2 = &i2c2;
 		i2c8 = &i2c8;
 		mmc0 = &emmc;
+		mmc1 = &sdhci0;
 		serial0 = &uart0;
 	};
 
@@ -282,7 +283,7 @@ buck6 {
 				regulator-always-on;
 			};
 
-			aldo1 {
+			aldo1: aldo1 {
 				regulator-min-microvolt = <500000>;
 				regulator-max-microvolt = <3400000>;
 				regulator-boot-on;
@@ -417,6 +418,24 @@ uboot@a00000 {
 	};
 };
 
+&sdhci0 {
+	pinctrl-names = "default", "uhs";
+	pinctrl-0 = <&mmc1_cfg>;
+	pinctrl-1 = <&mmc1_uhs_cfg>;
+	bus-width = <4>;
+	cd-gpios = <&gpio K1_GPIO(80) (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
+	no-mmc;
+	no-sdio;
+	disable-wp;
+	cap-sd-highspeed;
+	vmmc-supply = <&buck4_3v3>;
+	vqmmc-supply = <&aldo1>;
+	sd-uhs-sdr25;
+	sd-uhs-sdr50;
+	sd-uhs-sdr104;
+	status = "okay";
+};
+
 &uart0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&uart0_2_cfg>;
-- 
2.53.0


_______________________________________________
linux-riscv mailing list
linux-riscv@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-riscv

  parent reply	other threads:[~2026-05-14 16:04 UTC|newest]

Thread overview: 18+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-05-14 15:56 [PATCH 0/4] riscv: dts: spacemit: improve Milk-V Jupiter device tree Aurelien Jarno
2026-05-14 15:56 ` Aurelien Jarno
2026-05-14 15:56 ` [PATCH 1/4] riscv: dts: spacemit: set console baud rate on Milk-V Jupiter Aurelien Jarno
2026-05-14 15:56   ` Aurelien Jarno
2026-05-14 15:56 ` [PATCH 2/4] riscv: dts: spacemit: sort aliases " Aurelien Jarno
2026-05-14 15:56   ` Aurelien Jarno
2026-05-14 15:56 ` [PATCH 3/4] riscv: dts: spacemit: enable eMMC " Aurelien Jarno
2026-05-14 15:56   ` Aurelien Jarno
2026-05-15  6:49   ` E Shattow
2026-05-15  6:49     ` E Shattow
2026-05-15  7:48     ` Aurelien Jarno
2026-05-15  7:48       ` Aurelien Jarno
2026-05-16  5:37       ` Yixun Lan
2026-05-16  5:37         ` Yixun Lan
2026-05-16 14:09         ` E Shattow
2026-05-16 14:09           ` E Shattow
2026-05-14 15:56 ` Aurelien Jarno [this message]
2026-05-14 15:56   ` [PATCH 4/4] riscv: dts: spacemit: enable SD card support " Aurelien Jarno

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20260514160356.1642075-5-aurelien@aurel32.net \
    --to=aurelien@aurel32.net \
    --cc=alex@ghiti.fr \
    --cc=aou@eecs.berkeley.edu \
    --cc=conor+dt@kernel.org \
    --cc=devicetree@vger.kernel.org \
    --cc=dlan@kernel.org \
    --cc=krzk+dt@kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-riscv@lists.infradead.org \
    --cc=palmer@dabbelt.com \
    --cc=pjw@kernel.org \
    --cc=robh@kernel.org \
    --cc=spacemit@lists.linux.dev \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body. 
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.