[RFC PATCH v8 4/4] docs: cgroup-v2: document the iocost BPF cost model attachment

[Tao Cui <cui.tao@linux.dev>]

Document the BPF cost model attachment in the io.cost.model section
of the cgroup v2 documentation: attaching an iocost_model_ops
struct_ops to a device by its major:minor, the model=bpf readback
while attached (ctrl keeps describing the coefficients), that
detaching restores the builtin model, and that ctrl= writes never
select a model.

Signed-off-by: Tao Cui <cuitao@kylinos.cn>
---
 Documentation/admin-guide/cgroup-v2.rst | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/Documentation/admin-guide/cgroup-v2.rst b/Documentation/admin-guide/cgroup-v2.rst
index 7fe950425216..5e780bdcf324 100644
--- a/Documentation/admin-guide/cgroup-v2.rst
+++ b/Documentation/admin-guide/cgroup-v2.rst
@@ -2117,8 +2117,27 @@ IO Interface Files
 	  =====		================================
 	  ctrl		"auto" or "user"
 	  model		The cost model in use - "linear"
+			or "bpf" while the BPF model
+			is in use
 	  =====		================================
 
+	When CONFIG_BLK_CGROUP_IOCOST_BPF is enabled, a BPF cost model
+	can be attached to a device by loading an "iocost_model_ops"
+	struct_ops with the whole disk's major:minor in its "dev" member
+	(a partition's major:minor is rejected).  Attaching creates the
+	controller if needed, like an io.cost.model write does, and
+	switches the device's pricing to the model; enabling and
+	disabling the controller stays with io.cost.qos.  While a model
+	is attached, "model" selects between it and the builtin model:
+	"model=bpf" switches to the attached model and "model=linear"
+	switches back to the builtin model, and neither detaches the
+	struct_ops; only detaching removes the model, after which
+	"model=bpf" fails.  "ctrl" keeps describing the builtin
+	coefficients, which are kept while the BPF model is in use and
+	take effect again when switched back, and the automatic profile
+	stepping does not switch profiles while the BPF model is in
+	use.
+
 	When "ctrl" is "auto", the kernel may change all parameters
 	dynamically.  When "ctrl" is set to "user" or any other
 	parameters are written to, "ctrl" become "user" and the
-- 
2.43.0