All of lore.kernel.org
 help / color / mirror / Atom feed
From: John Crispin <john@phrozen.org>
To: Lorenzo Bianconi <lorenzo@kernel.org>, Lee Jones <lee@kernel.org>,
	Rob Herring <robh@kernel.org>,
	Krzysztof Kozlowski <krzk+dt@kernel.org>,
	Conor Dooley <conor+dt@kernel.org>,
	Linus Walleij <linusw@kernel.org>,
	Bartosz Golaszewski <brgl@kernel.org>
Cc: Ahmed Naseef <naseefkm@gmail.com>,
	Benjamin Larsson <benjamin.larsson@genexis.eu>,
	Christian Marangi <ansuelsmth@gmail.com>,
	devicetree@vger.kernel.org, lei.dong@airoha.com,
	Linqi.zhang@airoha.com, linux-gpio@vger.kernel.org,
	linux-kernel@vger.kernel.org, linux-mediatek@lists.infradead.org,
	mfd@lists.linux.dev,
	Mikhail Kshevetskiy <mikhail.kshevetskiy@iopsys.eu>,
	Rajeev.kumar@airoha.com, upstream@airoha.com,
	Weifeng.xu@airoha.com, zhengping.zhang@airoha.com
Subject: [PATCH 2/7] pinctrl: airoha: add per pin mode field mux
Date: Tue, 10 Nov 2026 18:39:36 +0100	[thread overview]
Message-ID: <20261110173941.301478-3-john@phrozen.org> (raw)
In-Reply-To: <20261110173941.301478-1-john@phrozen.org>

Newer Airoha SoCs select the function of a pin through a mode field in
a dedicated IOMUX block instead of through function specific bits in
the chip SCU. The AN7589 has a 4 bit field per pin, eight pins per 32
bit register. A group can then need one register write per pin, and
the two entry regmap[] of a function group cannot carry that.

Let a function group supply a pin_modes[] array, parallel to the pins
of the group. When it is set, set_mux writes each mode into the IOMUX
regmap and then applies the regmap[] entries of the group, so a group
can combine its pin modes with a register write in the GPIO block.

A SoC with an IOMUX describes it in its match data with struct
airoha_pinctrl_iomux, which holds the width of the mode field. Probe
then takes the regmap from the airoha,iomux phandle.

No functional change for the existing SoCs.

Signed-off-by: John Crispin <john@phrozen.org>
---
 drivers/pinctrl/airoha/airoha-common.h  | 14 ++++++++
 drivers/pinctrl/airoha/pinctrl-airoha.c | 48 +++++++++++++++++++++++++
 2 files changed, 62 insertions(+)

diff --git a/drivers/pinctrl/airoha/airoha-common.h b/drivers/pinctrl/airoha/airoha-common.h
index 850e733db15a..7a0cb8924e71 100644
--- a/drivers/pinctrl/airoha/airoha-common.h
+++ b/drivers/pinctrl/airoha/airoha-common.h
@@ -49,6 +49,12 @@
 		.group_size = ARRAY_SIZE(table##_func_group),		\
 	}
 
+#define PINCTRL_MODE_FUNC_GROUP(id, table)				\
+	{								\
+		.name = id,						\
+		.pin_modes = table##_modes,				\
+	}
+
 #define PINCTRL_CONF_DESC(p, offset, mask)				\
 	{								\
 		.pin = p,						\
@@ -75,6 +81,7 @@ struct airoha_pinctrl_func_group {
 		u32 val;
 	} regmap[2];
 	int regmap_size;
+	const u8 *pin_modes;
 };
 
 struct airoha_pinctrl_func {
@@ -102,6 +109,10 @@ struct airoha_gpiochip_regs {
 
 extern const struct airoha_gpiochip_regs airoha_gpiochip_regs_64;
 
+struct airoha_pinctrl_iomux {
+	u8 mode_bits;
+};
+
 struct airoha_pinctrl_confs_info {
 	const struct airoha_pinctrl_conf *confs;
 	unsigned int num_confs;
@@ -126,6 +137,8 @@ struct airoha_pinctrl {
 	const struct airoha_pinctrl_confs_info *confs_info;
 
 	struct regmap *chip_scu;
+	struct regmap *iomux;
+	const struct airoha_pinctrl_iomux *iomux_info;
 	struct regmap *regmap;
 
 	struct gpio_chip gpiochip;
@@ -135,6 +148,7 @@ struct airoha_pinctrl {
 
 struct airoha_pinctrl_match_data {
 	const char *chip_scu_compatible;
+	const struct airoha_pinctrl_iomux *iomux_info;
 	const char *pinctrl_name;
 	struct module *pinctrl_owner;
 	const struct airoha_gpiochip_regs *gpio_regs;
diff --git a/drivers/pinctrl/airoha/pinctrl-airoha.c b/drivers/pinctrl/airoha/pinctrl-airoha.c
index b50108826d8d..f9ae4020b764 100644
--- a/drivers/pinctrl/airoha/pinctrl-airoha.c
+++ b/drivers/pinctrl/airoha/pinctrl-airoha.c
@@ -401,6 +401,35 @@ static int airoha_pinctrl_add_gpiochip(struct airoha_pinctrl *pinctrl,
 }
 
 /* pinmux callbacks */
+static int airoha_pinmux_set_pin_mode(struct airoha_pinctrl *pinctrl,
+				      unsigned int pin, u8 mode)
+{
+	unsigned int mode_bits = pinctrl->iomux_info->mode_bits;
+	unsigned int modes_per_reg = sizeof(u32) * BITS_PER_BYTE / mode_bits;
+	unsigned int shift = (pin % modes_per_reg) * mode_bits;
+	unsigned int reg = (pin / modes_per_reg) * sizeof(u32);
+
+	return regmap_update_bits(pinctrl->iomux, reg,
+				  GENMASK(mode_bits - 1, 0) << shift,
+				  mode << shift);
+}
+
+static int airoha_pinmux_set_pin_modes(struct airoha_pinctrl *pinctrl,
+				       const struct group_desc *grp,
+				       const u8 *modes)
+{
+	int i, err;
+
+	for (i = 0; i < grp->grp.npins; i++) {
+		err = airoha_pinmux_set_pin_mode(pinctrl, grp->grp.pins[i],
+						 modes[i]);
+		if (err)
+			return err;
+	}
+
+	return 0;
+}
+
 static int airoha_pinmux_set_mux(struct pinctrl_dev *pctrl_dev,
 				 unsigned int selector,
 				 unsigned int group)
@@ -431,6 +460,15 @@ static int airoha_pinmux_set_mux(struct pinctrl_dev *pctrl_dev,
 		if (strcmp(group->name, grp->grp.name))
 			continue;
 
+		if (group->pin_modes) {
+			int err;
+
+			err = airoha_pinmux_set_pin_modes(pinctrl, grp,
+							  group->pin_modes);
+			if (err)
+				return err;
+		}
+
 		for (j = 0; j < group->regmap_size; j++) {
 			switch (group->regmap[j].mux) {
 			case AIROHA_FUNC_PWM_EXT_MUX:
@@ -824,6 +862,16 @@ int airoha_pinctrl_probe(struct platform_device *pdev)
 
 	pinctrl->chip_scu = map;
 
+	if (data->iomux_info) {
+		map = syscon_regmap_lookup_by_phandle(dev->of_node,
+						      "airoha,iomux");
+		if (IS_ERR(map))
+			return PTR_ERR(map);
+
+		pinctrl->iomux = map;
+		pinctrl->iomux_info = data->iomux_info;
+	}
+
 	/* Init pinctrl desc struct */
 	pinctrl->desc.name = data->pinctrl_name;
 	pinctrl->desc.owner = data->pinctrl_owner;
-- 
2.34.1


  parent reply	other threads:[~2026-11-10 17:39 UTC|newest]

Thread overview: 13+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-11-10 17:39 [PATCH 0/7] pinctrl: airoha: add AN7589 support John Crispin
2026-11-10 17:39 ` [PATCH 1/7] pinctrl: airoha: make gpio register layout per SoC John Crispin
2026-11-11 11:22   ` Lorenzo Bianconi
2026-11-10 17:39 ` John Crispin [this message]
2026-11-10 17:39 ` [PATCH 3/7] pinctrl: airoha: make the chip SCU optional John Crispin
2026-11-11 11:27   ` Lorenzo Bianconi
2026-11-10 17:39 ` [PATCH 4/7] pinctrl: airoha: mux a requested GPIO through the IOMUX John Crispin
2026-11-10 17:39 ` [PATCH 5/7] dt-bindings: pinctrl: airoha: add AN7589 John Crispin
2026-11-10 18:27   ` Conor Dooley
2026-11-10 17:39 ` [PATCH 6/7] pinctrl: airoha: move the GPIO register offsets to the common header John Crispin
2026-11-11 11:29   ` Lorenzo Bianconi
2026-11-10 17:39 ` [PATCH 7/7] pinctrl: airoha: add support of an7589 SoC John Crispin
2026-11-11 11:32   ` Lorenzo Bianconi

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20261110173941.301478-3-john@phrozen.org \
    --to=john@phrozen.org \
    --cc=Linqi.zhang@airoha.com \
    --cc=Rajeev.kumar@airoha.com \
    --cc=Weifeng.xu@airoha.com \
    --cc=ansuelsmth@gmail.com \
    --cc=benjamin.larsson@genexis.eu \
    --cc=brgl@kernel.org \
    --cc=conor+dt@kernel.org \
    --cc=devicetree@vger.kernel.org \
    --cc=krzk+dt@kernel.org \
    --cc=lee@kernel.org \
    --cc=lei.dong@airoha.com \
    --cc=linusw@kernel.org \
    --cc=linux-gpio@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mediatek@lists.infradead.org \
    --cc=lorenzo@kernel.org \
    --cc=mfd@lists.linux.dev \
    --cc=mikhail.kshevetskiy@iopsys.eu \
    --cc=naseefkm@gmail.com \
    --cc=robh@kernel.org \
    --cc=upstream@airoha.com \
    --cc=zhengping.zhang@airoha.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.