All of lore.kernel.org
 help / color / mirror / Atom feed
From: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
To: Tony Lindgren <tony@atomide.com>
Cc: linux-omap@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
	devicetree@vger.kernel.org,
	Linus Walleij <linus.walleij@linaro.org>,
	sakari.ailus@iki.fi
Subject: Re: [PATCH/RFC] ARM: omap3: Split the pinmux core device
Date: Sat, 21 Dec 2013 00:05:38 +0100	[thread overview]
Message-ID: <2088462.QJuQNc7iK5@avalon> (raw)
In-Reply-To: <20131219183003.GR27438@atomide.com>

Hi Tony,

On Thursday 19 December 2013 10:30:03 Tony Lindgren wrote:
> * Sebastian Reichel <sre@ring0.de> [131219 09:19]:
> > On Wed, Dec 04, 2013 at 06:11:50PM +0100, Laurent Pinchart wrote:
> > > The omap3_pmx_core pinmux device in the device tree handles the system
> > > controller module (SCM) PADCONFS fonction. Its control registers are
> > > split in two distinct areas, with other SCM registers in-between. Those
> > > other registers can't thus be requested by other drivers as the memory
> > > region gets reserved by the pinmux driver.
> > > 
> > > Split the omap3_pmx_core device tree node in two for the two memory
> > > regions.
> > > 
> > > Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
> > > ---
> > > 
> > >  arch/arm/boot/dts/omap3-beagle-xm.dts | 45 ++++++++++++++++++++++------
> > >  arch/arm/boot/dts/omap3-beagle.dts    | 28 +++++++++++++++-------
> > >  arch/arm/boot/dts/omap3-igep0020.dts  | 26 ++++++++++----------
> > >  arch/arm/boot/dts/omap3-zoom3.dts     | 19 ++++++++++-----
> > >  arch/arm/boot/dts/omap3.dtsi          | 13 +++++++++-
> > >  5 files changed, 95 insertions(+), 36 deletions(-)
> > > 
> > > While working on the OMAP3 ISP driver I've run into a failure to request
> > > a memory region already requested by the pinctrl-single driver. This
> > > patch is an attempt to fix the problem. An alternative approach would be
> > > to support multiple reg values in the pinctrl-single driver, but that
> > > might not be much cleaner. I'm open to suggestions.
> > 
> > Acked-By: Sebastian Reichel <sre@debian.org>
> > 
> > I haven't checked the board dts files, but the change in omap3.dtsi is
> > needed to "fix a external abort on non-linefetch" when doing
> > 
> > cat /sys/kernel/debug/pinctrl/.../pins
> > 
> > on my Nokia N900.
> 
> OK, that should be mentioned in the patch. Laurent, care to update the patch
> for that?

Done.

> We should also check that the register ranges match with Nishant's similar
> patch "[PATCH] ARM: dts: omap3: split pinctrl for core into two parts".

I've checked Nishanth's patch and updated mine as I had forgotten the LED pins 
on the IGEP boards. Reviewing the two patches side by side wouldn't hurt of 
course.

-- 
Regards,

Laurent Pinchart


WARNING: multiple messages have this Message-ID (diff)
From: laurent.pinchart@ideasonboard.com (Laurent Pinchart)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH/RFC] ARM: omap3: Split the pinmux core device
Date: Sat, 21 Dec 2013 00:05:38 +0100	[thread overview]
Message-ID: <2088462.QJuQNc7iK5@avalon> (raw)
In-Reply-To: <20131219183003.GR27438@atomide.com>

Hi Tony,

On Thursday 19 December 2013 10:30:03 Tony Lindgren wrote:
> * Sebastian Reichel <sre@ring0.de> [131219 09:19]:
> > On Wed, Dec 04, 2013 at 06:11:50PM +0100, Laurent Pinchart wrote:
> > > The omap3_pmx_core pinmux device in the device tree handles the system
> > > controller module (SCM) PADCONFS fonction. Its control registers are
> > > split in two distinct areas, with other SCM registers in-between. Those
> > > other registers can't thus be requested by other drivers as the memory
> > > region gets reserved by the pinmux driver.
> > > 
> > > Split the omap3_pmx_core device tree node in two for the two memory
> > > regions.
> > > 
> > > Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
> > > ---
> > > 
> > >  arch/arm/boot/dts/omap3-beagle-xm.dts | 45 ++++++++++++++++++++++------
> > >  arch/arm/boot/dts/omap3-beagle.dts    | 28 +++++++++++++++-------
> > >  arch/arm/boot/dts/omap3-igep0020.dts  | 26 ++++++++++----------
> > >  arch/arm/boot/dts/omap3-zoom3.dts     | 19 ++++++++++-----
> > >  arch/arm/boot/dts/omap3.dtsi          | 13 +++++++++-
> > >  5 files changed, 95 insertions(+), 36 deletions(-)
> > > 
> > > While working on the OMAP3 ISP driver I've run into a failure to request
> > > a memory region already requested by the pinctrl-single driver. This
> > > patch is an attempt to fix the problem. An alternative approach would be
> > > to support multiple reg values in the pinctrl-single driver, but that
> > > might not be much cleaner. I'm open to suggestions.
> > 
> > Acked-By: Sebastian Reichel <sre@debian.org>
> > 
> > I haven't checked the board dts files, but the change in omap3.dtsi is
> > needed to "fix a external abort on non-linefetch" when doing
> > 
> > cat /sys/kernel/debug/pinctrl/.../pins
> > 
> > on my Nokia N900.
> 
> OK, that should be mentioned in the patch. Laurent, care to update the patch
> for that?

Done.

> We should also check that the register ranges match with Nishant's similar
> patch "[PATCH] ARM: dts: omap3: split pinctrl for core into two parts".

I've checked Nishanth's patch and updated mine as I had forgotten the LED pins 
on the IGEP boards. Reviewing the two patches side by side wouldn't hurt of 
course.

-- 
Regards,

Laurent Pinchart

  reply	other threads:[~2013-12-20 23:05 UTC|newest]

Thread overview: 20+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2013-12-04 17:11 [PATCH/RFC] ARM: omap3: Split the pinmux core device Laurent Pinchart
2013-12-04 17:11 ` Laurent Pinchart
     [not found] ` <1386177110-26424-1-git-send-email-laurent.pinchart-ryLnwIuWjnjg/C1BVhZhaw@public.gmane.org>
2013-12-04 17:28   ` Tony Lindgren
2013-12-04 17:28     ` Tony Lindgren
2013-12-04 17:58     ` Laurent Pinchart
2013-12-04 17:58       ` Laurent Pinchart
2013-12-04 18:24       ` Tony Lindgren
2013-12-04 18:24         ` Tony Lindgren
2013-12-04 18:44         ` Laurent Pinchart
2013-12-04 18:44           ` Laurent Pinchart
2013-12-04 18:53           ` Tony Lindgren
2013-12-04 18:53             ` Tony Lindgren
2013-12-04 21:49             ` Tony Lindgren
2013-12-04 21:49               ` Tony Lindgren
2013-12-19 17:17 ` Sebastian Reichel
2013-12-19 17:17   ` Sebastian Reichel
2013-12-19 18:30   ` Tony Lindgren
2013-12-19 18:30     ` Tony Lindgren
2013-12-20 23:05     ` Laurent Pinchart [this message]
2013-12-20 23:05       ` Laurent Pinchart

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=2088462.QJuQNc7iK5@avalon \
    --to=laurent.pinchart@ideasonboard.com \
    --cc=devicetree@vger.kernel.org \
    --cc=linus.walleij@linaro.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-omap@vger.kernel.org \
    --cc=sakari.ailus@iki.fi \
    --cc=tony@atomide.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.