Re: [PATCH v2 1/2] Added ETH_SPEED_CAP bitmap in rte_eth_dev_info

[Thomas Monjalon <thomas.monjalon@6wind.com>]

Hi Marc,

2015-05-26 21:50, Marc Sune:
> Added constants and bitmap to struct rte_eth_dev_info to be used by PMDs.
> 
> Signed-off-by: Marc Sune <marc.sune@bisdn.de>
[...]
> +/**
> + * Device supported speeds
> + */
> +#define ETH_SPEED_CAP_NOT_PHY	(0)  /*< No phy media > */

Why not starting with lower values? Some new drivers may be interested
by lower speed.

> +#define ETH_SPEED_CAP_10M_HD	(1 << 0)  /*< 10 Mbps half-duplex> */
> +#define ETH_SPEED_CAP_10M_FD	(1 << 1)  /*< 10 Mbps full-duplex> */
> +#define ETH_SPEED_CAP_100M_HD	(1 << 2)  /*< 100 Mbps half-duplex> */
> +#define ETH_SPEED_CAP_100M_FD	(1 << 3)  /*< 100 Mbps full-duplex> */
> +#define ETH_SPEED_CAP_1G	(1 << 4)  /*< 1 Gbps > */
> +#define ETH_SPEED_CAP_2_5G	(1 << 5)  /*< 2.5 Gbps > */
> +#define ETH_SPEED_CAP_5G	(1 << 6)  /*< 5 Gbps > */
> +#define ETH_SPEED_CAP_10G	(1 << 7)  /*< 10 Mbps > */
> +#define ETH_SPEED_CAP_20G	(1 << 8)  /*< 20 Gbps > */
> +#define ETH_SPEED_CAP_25G	(1 << 9)  /*< 25 Gbps > */
> +#define ETH_SPEED_CAP_40G	(1 << 10)  /*< 40 Gbps > */
> +#define ETH_SPEED_CAP_50G	(1 << 11)  /*< 50 Gbps > */
> +#define ETH_SPEED_CAP_56G	(1 << 12)  /*< 56 Gbps > */
> +#define ETH_SPEED_CAP_100G	(1 << 13)  /*< 100 Gbps > */

We should note that rte_eth_link is using ETH_LINK_SPEED_* constants
which are not some bitmaps so we have to create these new constants.
Furthermore, rte_eth_link.link_speed is an uint16_t so it is limited
to 40G. Should we use some constant bitmaps here also?
What about removing _CAP suffix from your constants?

[...]
> +	uint32_t speed_capa;  /**< Supported speeds bitmap (ETH_SPEED_CAP_). */

If the constants are ETH_SPEED_CAP, why not wording this variable speed_cap?