* Re: RE: Uncompress Ok, but cannot run linux kernel...
@ 2001-05-08 11:21 zjuzhou
0 siblings, 0 replies; only message in thread
From: zjuzhou @ 2001-05-08 11:21 UTC (permalink / raw)
To: linuxppc-embedded
> Tom:
> I stumbled into the same problem a while ago.
>
> While I did not use a hardware debugger I used the sample demonstrating
> serial output to find that the Montavista kernel stops at the rfi
> instruction which is used to simultanoeusly turn on instruction and data
> address translation and to set the instruction pointer to the (remapped)
> start_here label. Unfortunately I lost my PPC hardware (405GP Walnut
> board) before I could find any solution.
>
I meet same problem now.When I add CONFIG_MODULES into config file
HHL 2.2.14 works well(my borad is mpc850),but after add it ,I meet same
situation :after uncompressing kernel ,it do noting.It shoud display
LINUX_BANNER.
If you find the solution,tell me.Thanks.
Dross
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2001-05-08 11:21 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2001-05-08 11:21 RE: Uncompress Ok, but cannot run linux kernel zjuzhou
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.