FCC on 8560 ADS

FCC on 8560 ADS

[Jose Almeida]

All,

I'm trying to get a linux 2.6 kernel up and running on an freescale 8560 
ADS board. I have every peace of this up and running apart from the FCC 
ethernet.

I've switched to the legacy mode, which now allow me to talk to the PHY 
and negocite properly @ 100BT FD.

But I don't seem to get any ethernet packet going out. The FCC 
controller does not seem to read the BDs, and all the packet's I'm 
placing in the BD just stay there for ever !

I'm wondering if you have a driver which works properlly ? I'm thinking 
on some wrong setup in the ioports, but is all seems to be correct !

I'm using a 2.6.9 kernel, but I also tryed other versions (2.6.11r4), 
with the same problems ...

Thanks
 Jose

Re: FCC on 8560 ADS

[Jose Almeida]

All,

Please cancel this request, I found the problem.
I had a switch (SW4) with the wrong setup.

Thanks - Jose

Jose Almeida wrote:

> All,
>
> I'm trying to get a linux 2.6 kernel up and running on an freescale 
> 8560 ADS board. I have every peace of this up and running apart from 
> the FCC ethernet.
>
> I've switched to the legacy mode, which now allow me to talk to the 
> PHY and negocite properly @ 100BT FD.
>
> But I don't seem to get any ethernet packet going out. The FCC 
> controller does not seem to read the BDs, and all the packet's I'm 
> placing in the BD just stay there for ever !
>
> I'm wondering if you have a driver which works properlly ? I'm 
> thinking on some wrong setup in the ioports, but is all seems to be 
> correct !
>
> I'm using a 2.6.9 kernel, but I also tryed other versions (2.6.11r4), 
> with the same problems ...
>
> Thanks
> Jose
> _______________________________________________
> Linuxppc-embedded mailing list
> Linuxppc-embedded@ozlabs.org
> https://ozlabs.org/mailman/listinfo/linuxppc-embedded
>
>