* how to "slow down" multipath
@ 2006-02-05 2:16 Bernd Zeimetz
0 siblings, 0 replies; only message in thread
From: Bernd Zeimetz @ 2006-02-05 2:16 UTC (permalink / raw)
To: dm-devel
Hi,
we unfortunately have some errors on SCSI level on the FC bus to an EMC
CX sometimes, we'll have to figure out if that's a problem with the HBAs
or the CX. But in the meantime it would be good to have a way to stop
multipath(d) from swtiching back to the path witch had the scsi error
ASAP, as these errors repeat within seconds, which results in a lot of
path switches just because multipathd allready uses the default path
again. Although switching back to the normal path is normally nothing
bad, in this case it's something we'd prefer not to have.
Any ideas to this?
Thanks a lot,
best regards,
Bernd
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2006-02-05 2:16 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2006-02-05 2:16 how to "slow down" multipath Bernd Zeimetz
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.