Re: AW: [Xenomai-core] vxworks-skin taskSpawn

[Philippe Gerum <rpm@xenomai.org>]

Roderik_Wildenburg@domain.hid wrote:
> Dear Gilles,
> 
> perhaps I should have mentioned in my earlier postings that I am using a PowerPC platform. I hope this does not nullify your prior analyses.
> As the following output shows, my timer is running in onshot mode :
> 
> ~ # cat /proc/xenomai/timer
> status=oneshot:setup=40:tickval=1:jiffies=940509634545 
> 
> so, the prerequisites for uvm module should be correct !?
> Is the default timing something I can influence with the vxWorks-API ? In the examples satch.c and koan.c I can´t see any function call refering to timer mode manipulation.
> 

I've run the satch example successfully on an Icecube board here using -rc2. 
What's the status of this issue on your side? Was it a timer configuration issue 
as suspected by Gilles?

> Best regards 
> Roderik
> 
> 
>>This looks like a configuration issue: I get a similar 
>>behaviour when configuring periodic timing by default and 
>>loading the native module before the uvm module. The uvm skin 
>>needs aperiodic timing.
>>
>>The UVM skin should refuse to start with an error instead of 
>>starting with the wrong timer. I am trying to fix this.
>>
>>-- 
>>
>>
>>					    Gilles Chanteperdrix.
>>
> 
> 
> _______________________________________________
> Xenomai-core mailing list
> Xenomai-core@domain.hid
> https://mail.gna.org/listinfo/xenomai-core
> 


-- 

Philippe.