* Re: [Linux-usb-users] Fwd: Re: 2.6.17-rc6-mm2 - USB issues [not found] <Pine.LNX.4.44L0.0606151102220.6879-100000@iolanthe.rowland.org> @ 2006-06-18 11:37 ` Johny 0 siblings, 0 replies; 2+ messages in thread From: Johny @ 2006-06-18 11:37 UTC (permalink / raw) To: Alan Stern; +Cc: akpm, kernel list, linux-acpi, Johny, USB development list All, I've now tested the following; 2.6.17-rc6-mm2 with the following patch applied; --- git-acpi.patch from ftp://ftp.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.17-rc6/2.6.17-rc6-mm2/broken-out/ --- With no difference to the end-result. Next I stripped out 802.11 generic support and acx111 drivers from the kernel (including the acpi patches) to check if it clashes, but the same errors occur.... Thirdly, I booted with acpi=off on the command line with two kernels, the stock 2.6.17-rc6-mm2 (no acpi patch and including acx111) and the one including the acpi patch and no acx111, the results were; acpi_patch; works a treat, picks up USB devices as expected. stock; works a treat, picks up USB devices as expected, and my acx111 card works too :) Now I'm looking for good suggestions again, this definitely looks like it is related to ACPI, hence the cc' to that list too, as requested by Andrew M. I'm happy to apply patches / config changes as appropriate and for those who may ask for my .config files, please see; http://www.agotnes.com/kernelStuff/config-2.6.17-rc6-mm2 http://www.agotnes.com/kernelStuff/config-2.6.17-rc6-mm2git-acpi_patch Also, I left the output of lspci there for reference; http://www.agotnes.com/kernelStuff/lspci Cheers, :)Johny Alan Stern wrote: > [Moved to linux-usb-devel in the hope of getting additional help] > > On Thu, 15 Jun 2006, Johny wrote: > >> Alan, >> >> See comments interspersed, thanks for your assistance :) >> >> Alan Stern wrote: >>> On Tue, 13 Jun 2006, Johny wrote: >>> >>>> Is this best suited to this mailing list? >>> It's appropriate. >>> >>>> I tried the kernel list with zero responses (so far ;), let me know if there is >>>> anywhere else this should go. >>> ... >>> >>>> Johny Ågotnes wrote: >>>>> All, >>>>> >>>>> My USB hub isn't recognised with the latest -mm series, whereas with >>>>> 2.6.16 vanilla it is picked up & used immediately. >>>>> >>>>> The error I get in dmesg is; >>>>> >>>>> hub 4-0:1.0: USB hub found >>>>> hub 4-0:1.0: 2 ports detected >>>>> usb 1-4: new high speed USB device using ehci_hcd and address 3 >>>>> ehci_hcd 0000:00:10.3: Unlink after no-IRQ? Controller is probably >>>>> using the wrong IRQ. >>> That last line is a clue. What interrupt numbers are assigned under >>> 2.6.16? If you unplug the SonyEricsson DCU-11 Cable before booting (and >>> leave it unplugged), what shows up in /proc/interrupts for both versions >>> of the kernel? >> See attached, both with the DCU-11 cable disconnected. > > From 2.6.16: > CPU0 > 0: 16101 XT-PIC timer > 1: 148 XT-PIC i8042 > 2: 0 XT-PIC cascade > 7: 0 XT-PIC parport0 > 9: 0 XT-PIC acpi > 10: 151 XT-PIC ehci_hcd:usb1, uhci_hcd:usb4 > 11: 0 XT-PIC uhci_hcd:usb2, uhci_hcd:usb3 > 12: 138 XT-PIC i8042 > 14: 172 XT-PIC ide0 > 15: 2458 XT-PIC ide1 > NMI: 0 > ERR: 0 > > From 2.6.17: > CPU0 > 0: 35651 XT-PIC-level timer > 1: 129 XT-PIC-level i8042 > 2: 0 XT-PIC-level cascade > 6: 3 XT-PIC-level floppy > 7: 0 XT-PIC-level parport0 > 9: 0 XT-PIC-level acpi > 10: 0 XT-PIC-level ehci_hcd:usb1, uhci_hcd:usb4 > 11: 1940 XT-PIC-level uhci_hcd:usb2, uhci_hcd:usb3, wlan0 > 12: 162 XT-PIC-level i8042 > 14: 171 XT-PIC-level ide0 > 15: 4251 XT-PIC-level ide1 > NMI: 0 > ERR: 0 > > There's nothing obviously wrong. > >>> Most likely this is a problem with the ACPI subsystem, not a USB problem. >>> >> I guessed USB due to the number of USB changes in the -mm series and, >> obviously, my USB devices stopped registering, however, I'd not know one >> from the other ;) > > What happens if you boot with "acpi=off" on the boot command line? > > Alan Stern > _______________________________________________ linux-usb-devel@lists.sourceforge.net To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel ^ permalink raw reply [flat|nested] 2+ messages in thread
* Re: [Linux-usb-users] Fwd: Re: 2.6.17-rc6-mm2 - USB issues @ 2006-06-18 11:37 ` Johny 0 siblings, 0 replies; 2+ messages in thread From: Johny @ 2006-06-18 11:37 UTC (permalink / raw) To: Alan Stern; +Cc: Johny, USB development list, kernel list, linux-acpi, akpm All, I've now tested the following; 2.6.17-rc6-mm2 with the following patch applied; --- git-acpi.patch from ftp://ftp.kernel.org/pub/linux/kernel/people/akpm/patches/2.6/2.6.17-rc6/2.6.17-rc6-mm2/broken-out/ --- With no difference to the end-result. Next I stripped out 802.11 generic support and acx111 drivers from the kernel (including the acpi patches) to check if it clashes, but the same errors occur.... Thirdly, I booted with acpi=off on the command line with two kernels, the stock 2.6.17-rc6-mm2 (no acpi patch and including acx111) and the one including the acpi patch and no acx111, the results were; acpi_patch; works a treat, picks up USB devices as expected. stock; works a treat, picks up USB devices as expected, and my acx111 card works too :) Now I'm looking for good suggestions again, this definitely looks like it is related to ACPI, hence the cc' to that list too, as requested by Andrew M. I'm happy to apply patches / config changes as appropriate and for those who may ask for my .config files, please see; http://www.agotnes.com/kernelStuff/config-2.6.17-rc6-mm2 http://www.agotnes.com/kernelStuff/config-2.6.17-rc6-mm2git-acpi_patch Also, I left the output of lspci there for reference; http://www.agotnes.com/kernelStuff/lspci Cheers, :)Johny Alan Stern wrote: > [Moved to linux-usb-devel in the hope of getting additional help] > > On Thu, 15 Jun 2006, Johny wrote: > >> Alan, >> >> See comments interspersed, thanks for your assistance :) >> >> Alan Stern wrote: >>> On Tue, 13 Jun 2006, Johny wrote: >>> >>>> Is this best suited to this mailing list? >>> It's appropriate. >>> >>>> I tried the kernel list with zero responses (so far ;), let me know if there is >>>> anywhere else this should go. >>> ... >>> >>>> Johny Ågotnes wrote: >>>>> All, >>>>> >>>>> My USB hub isn't recognised with the latest -mm series, whereas with >>>>> 2.6.16 vanilla it is picked up & used immediately. >>>>> >>>>> The error I get in dmesg is; >>>>> >>>>> hub 4-0:1.0: USB hub found >>>>> hub 4-0:1.0: 2 ports detected >>>>> usb 1-4: new high speed USB device using ehci_hcd and address 3 >>>>> ehci_hcd 0000:00:10.3: Unlink after no-IRQ? Controller is probably >>>>> using the wrong IRQ. >>> That last line is a clue. What interrupt numbers are assigned under >>> 2.6.16? If you unplug the SonyEricsson DCU-11 Cable before booting (and >>> leave it unplugged), what shows up in /proc/interrupts for both versions >>> of the kernel? >> See attached, both with the DCU-11 cable disconnected. > > From 2.6.16: > CPU0 > 0: 16101 XT-PIC timer > 1: 148 XT-PIC i8042 > 2: 0 XT-PIC cascade > 7: 0 XT-PIC parport0 > 9: 0 XT-PIC acpi > 10: 151 XT-PIC ehci_hcd:usb1, uhci_hcd:usb4 > 11: 0 XT-PIC uhci_hcd:usb2, uhci_hcd:usb3 > 12: 138 XT-PIC i8042 > 14: 172 XT-PIC ide0 > 15: 2458 XT-PIC ide1 > NMI: 0 > ERR: 0 > > From 2.6.17: > CPU0 > 0: 35651 XT-PIC-level timer > 1: 129 XT-PIC-level i8042 > 2: 0 XT-PIC-level cascade > 6: 3 XT-PIC-level floppy > 7: 0 XT-PIC-level parport0 > 9: 0 XT-PIC-level acpi > 10: 0 XT-PIC-level ehci_hcd:usb1, uhci_hcd:usb4 > 11: 1940 XT-PIC-level uhci_hcd:usb2, uhci_hcd:usb3, wlan0 > 12: 162 XT-PIC-level i8042 > 14: 171 XT-PIC-level ide0 > 15: 4251 XT-PIC-level ide1 > NMI: 0 > ERR: 0 > > There's nothing obviously wrong. > >>> Most likely this is a problem with the ACPI subsystem, not a USB problem. >>> >> I guessed USB due to the number of USB changes in the -mm series and, >> obviously, my USB devices stopped registering, however, I'd not know one >> from the other ;) > > What happens if you boot with "acpi=off" on the boot command line? > > Alan Stern > ^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2006-06-18 11:37 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
[not found] <Pine.LNX.4.44L0.0606151102220.6879-100000@iolanthe.rowland.org>
2006-06-18 11:37 ` [Linux-usb-users] Fwd: Re: 2.6.17-rc6-mm2 - USB issues Johny
2006-06-18 11:37 ` Johny
This is an external index of several public inboxes, see mirroring instructions on how to clone and mirror all data and code used by this external index.