* [Xenomai-help] OT but advice required if possible. CAN related
@ 2007-03-29 16:51 Roland Tollenaar
0 siblings, 0 replies; only message in thread
From: Roland Tollenaar @ 2007-03-29 16:51 UTC (permalink / raw)
To: Xenomai-help
Hi,
This is slightly off topic but the only relevant place to post this
question.
I have attached remote IO to my peak CAN adaptor (make WAGO) in the
assumption that I will be able to control DI,DO and AO at a speed
limited mainly by the bus speed. It appears that this kind of CAN
hardware is very slow (5ms fastest update interval as opposed to the 1ms
I require).
The bus is cetainly not the limitation as I have sensors operating on
the same bus at 0.5ms interval with no problem.
WAGO concedes that their hardware cannot do any better than 5ms so I
have a problem. Does anyone know of remote IO that is fast enough for
1ms control intervals?
AFAIK Beckhoff has the same shortcoming.
Advice on this would be much appreciated.
Kind regards,
Roland Tollenaar.
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2007-03-29 16:51 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2007-03-29 16:51 [Xenomai-help] OT but advice required if possible. CAN related Roland Tollenaar
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.