All of lore.kernel.org
 help / color / mirror / Atom feed
* Unable to mount root fs on unknown-block(1,0)
@ 2007-04-16  4:24 gshan
  2007-04-16  4:46 ` gshan
  0 siblings, 1 reply; 2+ messages in thread
From: gshan @ 2007-04-16  4:24 UTC (permalink / raw)
  To: linux-kernel

Hi Folks,

I got problem to boot linux 2.6.25 using u-boot-1.1.4, any ideas?

-------------------------

U-Boot 1.1.4 (Apr 14 2007 - 00:57:01)

CPU:   XPC850xxZTB at 50 MHz: 2 kB I-Cache 1 kB D-Cache
Board: ### No HW ID - assuming TQM8xxL
DRAM:   8 MB
FLASH:  4 MB
In:    serial
Out:   serial
Err:   serial
Net:   SCC ETHERNET
Hit any key to stop autoboot:  0
Using SCC ETHERNET device
TFTP from server 90.0.0.1; our IP address is 90.0.0.2
Filename 'uImage'.
Load address: 0x100000
Loading: #################################################################
         #################################################################
         ################################
done
Bytes transferred = 825541 (c98c5 hex)

=> printenv
bootdelay=5
baudrate=9600
loads_echo=1
ethact=SCC ETHERNET
netmask=0xff000000
vlan=0xffff
nvlan=0xffff
clocks_in_mhz=1
bootcmd=tftp 0x100000 uImage
autostart=no
filesize=c98c5
fileaddr=100000
ipaddr=90.0.0.2
serverip=90.0.0.1
bootargs=root=/dev/ram rw
stdin=serial
stdout=serial
stderr=serial

Environment size: 293/16380 bytes
=> bdinfo
memstart    = 0x00000000
memsize     = 0x00800000
flashstart  = 0x10000000
flashsize   = 0x00400000
flashoffset = 0x00021000
sramstart   = 0x00000000
sramsize    = 0x00800000
immr_base   = 0xFFF00000
bootflags   = 0x00000001
intfreq     =     50 MHz
busfreq     =     50 MHz
ethaddr     = 00:00:00:00:00:00
IP addr     = 90.0.0.2
baudrate    =   9600 bps


=> tftp 0x200000 aaa
Using SCC ETHERNET device
TFTP from server 90.0.0.1; our IP address is 90.0.0.2
Filename 'aaa'.
Load address: 0x200000
Loading: #
done
Bytes transferred = 776 (308 hex)
=> bootm 0x100000 0x200000
## Booting image at 00100000 ...
   Image Name:   Linux-2.6.15
   Created:      2007-04-15  16:56:44 UTC
   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
   Data Size:    825477 Bytes = 806.1 kB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
## Loading RAMDisk Image at 00200000 ...
   Image Name:   ramdisk
   Created:      2007-04-15  17:31:31 UTC
   Image Type:   PowerPC Linux RAMDisk Image (gzip compressed)
   Data Size:    712 Bytes =  0.7 kB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK
   Loading Ramdisk to 007b8000, end 007b82c8 ... OK
Linux version 2.6.15 (root@localhost.localdomain) (gcc version 4.0.0 
(DENX ELDK 4.0 4.0.0)) #182 Mon Apr 16 00:56:43 CST 2007
Built 1 zonelists
Kernel command line: root=/dev/ram rw
PID hash table entries: 64 (order: 6, 1024 bytes)
50
Decrementer Frequency = 187500000/60
Console: colour dummy device 80x25
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 6236k available (1408k kernel code, 364k data, 84k init, 0k highmem)
Mount-cache hash table entries: 512
checking if image is initramfs...it isn't (no cpio magic); looks like an 
initrd
Freeing initrd memory: 0k freed
NET: Registered protocol family 16
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
Generic RTC Driver v1.07
Serial: CPM driver $Revision: 0.01 $
ttyCPM0 at MMIO 0xfff00a80 (irq = 20) is a CPM UART
RAMDISK driver initialized: 2 RAM disks of 1024K size 1024 blocksize
loop: loaded (max 8 devices)
eth0: CPM ENET Version 0.2 on SCC1, 00:00:00:00:00:00
NET: Registered protocol family 2
IP route cache hash table entries: 128 (order: -3, 512 bytes)
TCP established hash table entries: 512 (order: -1, 2048 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
RAMDISK: Compressed image found at block 0
Kernel panic - not syncing: VFS: Unable to mount root fs on 
unknown-block(1,0)
 <0>Rebooting in 180 seconds..

Thanks,
Gavin


^ permalink raw reply	[flat|nested] 2+ messages in thread

* Re: Unable to mount root fs on unknown-block(1,0)
  2007-04-16  4:24 Unable to mount root fs on unknown-block(1,0) gshan
@ 2007-04-16  4:46 ` gshan
  0 siblings, 0 replies; 2+ messages in thread
From: gshan @ 2007-04-16  4:46 UTC (permalink / raw)
  To: gshan; +Cc: linux-kernel

Sorry, the version of linux should be 2.6.15 for MPC8xx, which is 
included in ELDK.

gshan wrote:
> Hi Folks,
>
> I got problem to boot linux 2.6.25 using u-boot-1.1.4, any ideas?
>
> -------------------------
>
> U-Boot 1.1.4 (Apr 14 2007 - 00:57:01)
>
> CPU:   XPC850xxZTB at 50 MHz: 2 kB I-Cache 1 kB D-Cache
> Board: ### No HW ID - assuming TQM8xxL
> DRAM:   8 MB
> FLASH:  4 MB
> In:    serial
> Out:   serial
> Err:   serial
> Net:   SCC ETHERNET
> Hit any key to stop autoboot:  0
> Using SCC ETHERNET device
> TFTP from server 90.0.0.1; our IP address is 90.0.0.2
> Filename 'uImage'.
> Load address: 0x100000
> Loading: 
> #################################################################
>         #################################################################
>         ################################
> done
> Bytes transferred = 825541 (c98c5 hex)
>
> => printenv
> bootdelay=5
> baudrate=9600
> loads_echo=1
> ethact=SCC ETHERNET
> netmask=0xff000000
> vlan=0xffff
> nvlan=0xffff
> clocks_in_mhz=1
> bootcmd=tftp 0x100000 uImage
> autostart=no
> filesize=c98c5
> fileaddr=100000
> ipaddr=90.0.0.2
> serverip=90.0.0.1
> bootargs=root=/dev/ram rw
> stdin=serial
> stdout=serial
> stderr=serial
>
> Environment size: 293/16380 bytes
> => bdinfo
> memstart    = 0x00000000
> memsize     = 0x00800000
> flashstart  = 0x10000000
> flashsize   = 0x00400000
> flashoffset = 0x00021000
> sramstart   = 0x00000000
> sramsize    = 0x00800000
> immr_base   = 0xFFF00000
> bootflags   = 0x00000001
> intfreq     =     50 MHz
> busfreq     =     50 MHz
> ethaddr     = 00:00:00:00:00:00
> IP addr     = 90.0.0.2
> baudrate    =   9600 bps
>
>
> => tftp 0x200000 aaa
> Using SCC ETHERNET device
> TFTP from server 90.0.0.1; our IP address is 90.0.0.2
> Filename 'aaa'.
> Load address: 0x200000
> Loading: #
> done
> Bytes transferred = 776 (308 hex)
> => bootm 0x100000 0x200000
> ## Booting image at 00100000 ...
>   Image Name:   Linux-2.6.15
>   Created:      2007-04-15  16:56:44 UTC
>   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
>   Data Size:    825477 Bytes = 806.1 kB
>   Load Address: 00000000
>   Entry Point:  00000000
>   Verifying Checksum ... OK
>   Uncompressing Kernel Image ... OK
> ## Loading RAMDisk Image at 00200000 ...
>   Image Name:   ramdisk
>   Created:      2007-04-15  17:31:31 UTC
>   Image Type:   PowerPC Linux RAMDisk Image (gzip compressed)
>   Data Size:    712 Bytes =  0.7 kB
>   Load Address: 00000000
>   Entry Point:  00000000
>   Verifying Checksum ... OK
>   Loading Ramdisk to 007b8000, end 007b82c8 ... OK
> Linux version 2.6.15 (root@localhost.localdomain) (gcc version 4.0.0 
> (DENX ELDK 4.0 4.0.0)) #182 Mon Apr 16 00:56:43 CST 2007
> Built 1 zonelists
> Kernel command line: root=/dev/ram rw
> PID hash table entries: 64 (order: 6, 1024 bytes)
> 50
> Decrementer Frequency = 187500000/60
> Console: colour dummy device 80x25
> Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
> Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
> Memory: 6236k available (1408k kernel code, 364k data, 84k init, 0k 
> highmem)
> Mount-cache hash table entries: 512
> checking if image is initramfs...it isn't (no cpio magic); looks like 
> an initrd
> Freeing initrd memory: 0k freed
> NET: Registered protocol family 16
> io scheduler noop registered
> io scheduler anticipatory registered
> io scheduler deadline registered
> io scheduler cfq registered
> Generic RTC Driver v1.07
> Serial: CPM driver $Revision: 0.01 $
> ttyCPM0 at MMIO 0xfff00a80 (irq = 20) is a CPM UART
> RAMDISK driver initialized: 2 RAM disks of 1024K size 1024 blocksize
> loop: loaded (max 8 devices)
> eth0: CPM ENET Version 0.2 on SCC1, 00:00:00:00:00:00
> NET: Registered protocol family 2
> IP route cache hash table entries: 128 (order: -3, 512 bytes)
> TCP established hash table entries: 512 (order: -1, 2048 bytes)
> TCP bind hash table entries: 512 (order: -1, 2048 bytes)
> TCP: Hash tables configured (established 512 bind 512)
> TCP reno registered
> TCP bic registered
> NET: Registered protocol family 1
> NET: Registered protocol family 17
> RAMDISK: Compressed image found at block 0
> Kernel panic - not syncing: VFS: Unable to mount root fs on 
> unknown-block(1,0)
> <0>Rebooting in 180 seconds..
>
> Thanks,
> Gavin
>
> -
> To unsubscribe from this list: send the line "unsubscribe 
> linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at  http://www.tux.org/lkml/


^ permalink raw reply	[flat|nested] 2+ messages in thread

end of thread, other threads:[~2007-04-16  4:46 UTC | newest]

Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2007-04-16  4:24 Unable to mount root fs on unknown-block(1,0) gshan
2007-04-16  4:46 ` gshan

This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.