Re: zImage.elf loads but does not start

[Andrei Konovalov <akonovalov@ru.mvista.com>]

AFAICT, the TEMAC device has not been registered on the platform bus.
You should add this stuff to arch/ppc/syslib/virtex_devices.c
(if you use the recent patches by Grant Likely).

xtemac_g.c is not used in 2.6 TEMAC driver(s I have seen).

Thanks,
Andrei

Mirek23 wrote:
> Thanks for the suggestions. I have changed the command line argument: 
> console:ttl0 -> ttyUL0 and kernel has booted up to the point to mount the
> root file system. 
> 
> I have set up the kernel to mount the root file systems via the nfs. I have
> started the nfs server on the remote pc. 
> Unfortunately the kernel did not mount the nfs root file system. The strange
> thing is that during booting the kernel I did not see any entry which refers
> to the TEMAC driver (which I have enabled in the kernel). 
> 
> I have noticed that in the drivers/net/xilinx_temac directory there is a
> file xtemac_g.c. It creates the global variable (a table) which contains all
> fo the definitions to configure TEMAC interface. All of the definitions used
> in the xtemac_g.c file come from xparameters_ml403.h. The strange thing is
> that this xtemac_g.c is not include in the Makefile to be compiled. 
> 
> I have incluede that file to the Makefile in order to use the TEMAC config
> parameters but when booting the kernel I did not find any diffrence
> compering to the driver which was originaly built without the xtemac_g.c 
> 
> The kernel boots as following: 
> 
> loaded at:     00400000 004F9138 
> board data at: 004F7120 004F7138 
> relocated to:  004040B8 004040D0 
> zimage at:     00404E45 004F6D1F 
> avail ram:     004FA000 04000000 
> 
> Linux/PPC load: console=ttyUL0,9600 root=/dev/nfs rw 
> nfsroot=129.129.130.106:/opt/eldk41/ppc_4xx,tcp 
> ip=129.129.129.29:255.255.255.0:LM200:eth0:off panic=1 
> 
> Uncompressing Linux...done. 
> Now booting the kernel 
> [    0.000000] Linux version 2.6.21-rc6-gd4bba4bf-dirty (root@pc5215) (gcc 
> version 4.0.2) #8 Tue Apr 24 14:51:35 CEST 2007 
> [    0.000000] Xilinx ML403 Reference System (Virtex-4 FX) 
> [    0.000000] Zone PFN ranges: 
> [    0.000000]   DMA             0 ->    16384 
> [    0.000000]   Normal      16384 ->    16384 
> [    0.000000] early_node_map[1] active PFN ranges 
> [    0.000000]     0:        0 ->    16384 
> [    0.000000] Built 1 zonelists.  Total pages: 16256 
> [    0.000000] Kernel command line: console=ttyUL0,9600 root=/dev/nfs rw 
> nfsroot=129.129.130.106:/opt/eldk41/ppc_4xx,tcp 
> ip=129.129.129.29:255.255.255.0:LM200:eth0:off panic=1 
> [    0.000000] Xilinx INTC #0 at 0x41200000 mapped to 0xFDFFF000 
> [    0.000000] PID hash table entries: 256 (order: 8, 1024 bytes) 
> [    0.000418] Console: colour dummy device 80x25 
> [    0.001487] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) 
> [    0.003212] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) 
> [    0.034378] Memory: 62720k available (1568k kernel code, 512k data, 96k 
> init, 0k highmem) 
> [    0.121194] Mount-cache hash table entries: 512 
> [    0.129484] NET: Registered protocol family 16 
> [    0.162553] NET: Registered protocol family 2 
> [    0.196706] IP route cache hash table entries: 1024 (order: 0, 4096 
> bytes) 
> [    0.197898] TCP established hash table entries: 2048 (order: 2, 16384 
> bytes) 
> [    0.198605] TCP bind hash table entries: 2048 (order: 1, 8192 bytes) 
> [    0.199040] TCP: Hash tables configured (established 2048 bind 2048) 
> [    0.199126] TCP reno registered 
> [    0.219619] io scheduler noop registered 
> [    0.219727] io scheduler anticipatory registered (default) 
> [    0.219807] io scheduler deadline registered 
> [    0.220367] io scheduler cfq registered 
> [    0.321949] uartlite.0: ttyUL0 at MMIO 0x40600003 (irq = 0) is a uartlite 
> [    2.254924] RAMDISK driver initialized: 1 RAM disks of 8192K size 1024 
> blocksize 
> [    2.346633] tun: Universal TUN/TAP device driver, 1.6 
> [    2.407407] tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com> 
> [    2.485482] mice: PS/2 mouse device common for all mice 
> [    2.548404] TCP cubic registered 
> [    2.587334] NET: Registered protocol family 1 
> [    2.639671] NET: Registered protocol family 17 
> [    3.197934] IP-Config: No network devices available. 
> [    3.259979] Looking up port of RPC 100003/2 on 129.129.130.106 
> [    3.331237] Root-NFS: Unable to get nfsd port number from server, using 
> default 
> [    3.419194] Looking up port of RPC 100005/1 on 129.129.130.106 
> [    3.490204] Root-NFS: Unable to get mountd port number from server, using 
> default 
> [    3.581337] Root-NFS: Server returned error -5 while mounting 
> /opt/eldk41/ppc_4xx 
> [    3.671568] VFS: Unable to mount root fs via NFS, trying floppy. 
> [    3.747080] VFS: Cannot open root device "nfs" or unknown-block(2,0) 
> [    3.823496] Please append a correct "root=" boot option 
> [    3.886242] Kernel panic - not syncing: VFS: Unable to mount root fs on 
> unknown-block(2,0) 
> [    3.985551] Rebooting in 1 seconds..<NULL> 
> 
> 
> 
> Would you have any idea why it did not recognise the TEMAC interface and how
> to configure the kernel that it recognises the network device. 
> 
> Mirek