Getting boot prompt with Minicom

Getting boot prompt with Minicom

[David Boosalis]

[-- Attachment #1: Type: text/plain, Size: 449 bytes --]

Hi All

My first post to this group, very much a newbie question for which I 
apologize.

I fired up my demo board, which is a SDP2430.  I  also have  connected 
my PC to the board via a serial cable attached to Port 1 (J9) .  I have 
set my Minicom settings to 115200 8 N 1, but am unable to get any prompt 
of any type. 

Are  these minicom settings correct ?

Should I have hardware flow control on ?


Thanks in advance for any help

-David





[-- Attachment #2: Type: text/plain, Size: 0 bytes --]

RE: Getting boot prompt with Minicom

[Syed Mohammed, Khasim]

Hi,

>I fired up my demo board, which is a SDP2430.  I  also have  connected
>my PC to the board via a serial cable attached to Port 1 (J9) .  I have
>set my Minicom settings to 115200 8 N 1, but am unable to get any prompt
>of any type.

If you are using u-boot as bootloder then your UART cable should be connected to J8 (UART 1 2). Next to the Ethernet switch.

>Are  these minicom settings correct ?
Minicom settings looks correct.

Regards,
Khasim