From: Jes Sorensen <jes@sgi.com>
To: yi.zhu@intel.com
Cc: linux-wireless@vger.kernel.org,
Tomas Winkler <tomas.winkler@intel.com>,
"John W. Linville" <linville@tuxdriver.com>
Subject: iwl4965 detection problem
Date: Thu, 25 Oct 2007 15:37:16 +0200 [thread overview]
Message-ID: <47209C0C.5010505@sgi.com> (raw)
Hi,
I just got my hands on a new Toshiba Portege R500 laptop, which comes
with the Intel 4965 chip in it. After installing the latest Fedora Core
8 test 3 on it, and updating the kernel I am still seeing a problem with
detection of the 4965 in my laptop.
Fedora Core 8 test 3 is based on a 2.6.23.1 kernel.
Basically on the first load of the iwl4965 module no interface is
detected, but if I rmmod and modprobe it again, it shows up and works
just fine.
I haven't yet tried the latest kernel.org tree on this box, but looking
through the git log, I don't see any commits that look like they were
addressing this problem.
Is this a problem you have heard about before? Anything information I
can provide to help?
I have attached the lspci -vv entry for this device, as well as the
dmesg output.
Cheers,
Jes
02:00.0 Network controller: Intel Corporation PRO/Wireless 4965 AG or
AGN Network Connection (rev 61)
Subsystem: Intel Corporation Unknown device 1101
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 0, Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 2300
Region 0: Memory at ff8fe000 (64-bit, non-prefetchable) [size=8K]
Capabilities: [c8] Power Management version 3
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [d0] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0
Enable+
Address: 00000000fee0300c Data: 41a9
Capabilities: [e0] Express Endpoint IRQ 0
Device: Supported: MaxPayload 128 bytes, PhantFunc 0, ExtTag-
Device: Latency L0s <512ns, L1 unlimited
Device: AtnBtn- AtnInd- PwrInd-
Device: Errors: Correctable- Non-Fatal- Fatal- Unsupported-
Device: RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop+
Device: MaxPayload 128 bytes, MaxReadReq 128 bytes
Link: Supported Speed 2.5Gb/s, Width x1, ASPM L0s L1, Port 0
Link: Latency L0s <128ns, L1 <64us
Link: ASPM L0s Enabled RCB 64 bytes CommClk+ ExtSynch-
Link: Speed 2.5Gb/s, Width x1
dmesg output:
First time it's loaded:
firewire_ohci: Added fw-ohci device 0000:03:0b.1, OHCI version 1.10
sdhci: SDHCI controller found at 0000:03:0b.3 [104c:803c] (rev 0)
PCI: Enabling device 0000:03:0b.3 (0000 -> 0002)
ACPI: PCI Interrupt 0000:03:0b.3[D] -> GSI 23 (level, low) -> IRQ 23
mmc0: SDHCI at 0x90005800 irq 23 DMA
iwl4965: Intel(R) Wireless WiFi Link 4965AGN driver for Linux, 1.1.17kds
iwl4965: Copyright(c) 2003-2007 Intel Corporation
ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 18 (level, low) -> IRQ 18
PCI: Setting latency timer of device 0000:02:00.0 to 64
iwl4965: Detected Intel Wireless WiFi Link 4965AGN
tpm_inf_pnp 00:0a: Found TPM with ID IFX0102
tpm_inf_pnp 00:0a: TPM found: config base 0x4e, data base 0x680, chip
version 0x000b, vendor id 0x15d1 (Infineon), product id 0x000b (SLB 9635
TT 1.2)
intel_rng: FWH not detected
.......
rmmod+modprobe'ing it again:
[drm] Initialized drm 1.1.0 20060810
[drm] Initialized i915 1.6.0 20060119 on minor 0
ACPI: PCI interrupt for device 0000:02:00.0 disabled
iwl4965: Intel(R) Wireless WiFi Link 4965AGN driver for Linux, 1.1.17kds
iwl4965: Copyright(c) 2003-2007 Intel Corporation
ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 18 (level, low) -> IRQ 18
PCI: Setting latency timer of device 0000:02:00.0 to 64
iwl4965: Detected Intel Wireless WiFi Link 4965AGN
iwl4965: Tunable channels: 13 802.11bg, 19 802.11a channels
phy1: Selected rate control algorithm 'iwl-4965-rs'
next reply other threads:[~2007-10-25 13:37 UTC|newest]
Thread overview: 14+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-10-25 13:37 Jes Sorensen [this message]
2007-10-25 13:45 ` iwl4965 detection problem Dan Williams
2007-10-25 14:15 ` Jes Sorensen
2007-10-25 17:32 ` Dan Williams
2007-10-26 8:05 ` Jes Sorensen
2007-10-26 12:30 ` John W. Linville
2007-10-26 12:45 ` Jes Sorensen
2007-10-26 14:10 ` Jes Sorensen
2007-10-26 14:41 ` John W. Linville
2007-10-26 14:43 ` Jes Sorensen
2007-10-26 15:17 ` Jes Sorensen
2007-10-26 15:23 ` dragoran
2007-10-26 16:50 ` John W. Linville
2007-10-29 1:14 ` Zhu Yi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=47209C0C.5010505@sgi.com \
--to=jes@sgi.com \
--cc=linux-wireless@vger.kernel.org \
--cc=linville@tuxdriver.com \
--cc=tomas.winkler@intel.com \
--cc=yi.zhu@intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.