Re: [PATCH] powerpc: i2c-mpc: make speed registers configurable via FDT

[Wolfgang Grandegger <wg@grandegger.com>]

Grant Likely wrote:
> On Fri, Jul 25, 2008 at 5:04 AM, Wolfgang Grandegger <wg@grandegger.com> wrote:
>> Jochen Friedrich wrote:
>>> Hi Wolfgang,
>>>
>>>> The I2C driver for the MPC currently uses a fixed speed hard-coded into
>>>> the driver. This patch adds the FDT properties "fdr" and "dfsrr" for the
>>>> corresponding I2C registers to make the speed configurable via FDT, e.g.:
>>>>
>>>>    i2c@3100 {
>>>>        compatible = "fsl-i2c";
>>>>        reg = <0x3100 0x100>;
>>>>        interrupts = <43 2>;
>>>>        interrupt-parent = <&mpic>;
>>>>        dfsrr = <0x20>;
>>>>        fdr = <0x03>;
>>>>    };
>>>
>>> Would it be possible to use the standard property "clock-frequency" for
>>> this
>>> and calculate the register settings in the driver?
> 
> Yes, please use something like clock-frequency or current-speed and do
> the calculation.
> 
>> Almost everything is possible in software, just for what price ;-). U-Boot
>> has some code in drivers/i2c/fsl_i2c.c to determine reasonable fdr and dfsrr
>> values for the MPC83/5/6xx boards. For the MPC82xx and MPC85xx it's even
>> more sophisticated.
>>
>> I was also thinking to just overtake the U-Boot settings if fdt and dfsrr is
>> not defined for the I2C node (instead of the debatable default values).
> 
> This is a perfectly valid option.  Personally, I'd prefer it encoded
> in the device tree, but if it looks like a valid speed has already
> been programmed in then I'm cool with the driver just preserving that.
>  If it turns out to causes problems the we can always change the code
> to be more conservative later.

How should the Linux driver decide if the registers have been already 
set by the boot-loader? The reset-values might be good as well. 
Therefore, if "clock-frequency" is not specified, the driver may simply 
not touch the fdr and dfsr registers (overtaking the values from the 
boot-loader).

What do you think.

Wolfgang.