[ath9k-devel] 2.6.28-rc8-wl Connection status bug?

[Brian <bnc@astronomicalresearchaustralia.org>]

Hi,
I have been having this 'problem' since rc7
Just installed the above kernel as the change log indicate some changes
in this area for ath9k.
The problem is that my router displays

	IP Address	Mode	Rate (Mbps)	Signal (%)
	0.0.0.0		802.11g	130		76

Now it should not be possible to get 130 out of 11g.

My router is set up to do both 11g/n, see below.
Prior to rc7 it used to show 11n and 300Mbps.

Not sure if it is relevant but I think the only thing I have changed in
the router is turning on the Wi-Fi Protected Setup.

How can I provide more detail/tests

By the way, looking through the change log I cannot believe how much
effort is going into this. Thanks one and all.

Brian

Wireless LAN
Wireless Radio : Enabled
802.11 Mode : Mixed 802.11n and 802.11g
Channel Width : 40MHz
Channel : 4
Secondary Channel : 8
WISH : Active
Wi-Fi Protected Setup : Enabled/Configured