Re: Mesh now completely broken on ath5k, latest git

[Steve Brown <sbrown@cortland.com>]

Bob Copeland wrote:
> On Thu, Dec 18, 2008 at 4:02 PM, Steve Brown <sbrown@cortland.com> wrote:
>   
>> Lots of these however:
>> Dec 18 15:53:20 fl-ws kernel: ath5k phy23: beacon queue 7 didn't stop?
>>     
>
> Can you change the if statement that prints that in ath5k_beacon_send() in
> base.c to capture the return value?  i.e.:
>
> int err;
> ...
>
> err = ath5k_hw_stop_tx_dma(ah, sc->bhalq);
> if (unlikely(err)) {
>     ATH5K_WARN(... "...didn't stop? %d\n", sc->bhalq, err);
> }
>
>   
>> If I make the same change to the current git, still no beacons. But, the
>> "queue 7" msgs persist.
>>     
>
> Not sure, I was about to blame ath5k_configure_filter() but I see it does
> turn on the beacons for mesh.
>
>   
Dec 18 18:04:26 fl-ws kernel: ath5k phy24: beacon queue 7 didn't stop? -16
Dec 18 18:04:26 fl-ws kernel: ath5k phy24: beacon queue 7 didn't stop? -16

BUSY?

I'm using a:
03:0a.0 Ethernet controller: Atheros Communications Inc. AR5413 
802.11abg NIC (rev 01)
    Subsystem: Atheros Communications Inc. EnGenius EMP-8602 (400mw) or 
Compex WLM54AG
    Flags: medium devsel, IRQ 22
    Memory at feab0000 (32-bit, non-prefetchable) [size=64K]
    Capabilities: [44] Power Management version 2
    Kernel modules: ath5k

Steve