From: Jochen Hebbrecht <jochenhebbrecht@gmail.com>
To: "Nicolas de Pesloüan" <nicolas.2p.debian@free.fr>
Cc: bridge@lists.linux-foundation.org
Subject: Re: [Bridge] Ubuntu: network bridging between wireless and wired connection fails
Date: Mon, 04 May 2009 23:06:52 +0200 [thread overview]
Message-ID: <49FF58EC.2090902@gmail.com> (raw)
In-Reply-To: <49FF4AF8.1050801@free.fr>
Nicolas de Pesloüan schreef:
>
> I think that the "Destination Host Unreachable" is caused by some sort
> of "down link", because wpa_supplicant failed to establish the wifi
> link. When eth1 is part of the br0, packets received on eth1 is
> "forwarded" to br0 and not available on eth1. So wpa_supplicant must
> be instructed to listen for incoming packets on br0, not on eth1.
>
> Can you try the exact same configuration, adding wpa-bridge br0 in the
> eth1 stanza, to inform wpa_supplicant where to listen from ?
>
> auto lo
> iface lo inet loopback
>
> auto eth1
> iface eth1 inet manual
> wpa-driver wext
> wpa-ssid ##SSID##
> wpa-ap-scan 1
> wpa-proto RSN
> wpa-pairwise CCMP
> wpa-group CCMP
> wpa-key-mgmt WPA-PSK
> wpa-psk ##PSK KEY##
> wpa-bridge br0 <--- HERE.
>
> auto br0
> iface br0 inet static
> bridge_ports eth1
> address 192.168.1.111
> netmask 255.255.255.0
> gateway 192.168.1.1
I changed the configuration and restarted the networking daemon. I'm
getting this output
jochus@Bacardi ~ $ sudo /etc/init.d/networking restart
* Reconfiguring network
interfaces...
ioctl[SIOCGIFINDEX]: No such device
Failed to open l2_packet connection for the bridge interface 'br0'
wpa_supplicant: /sbin/wpa_supplicant daemon failed to start
run-parts: /etc/network/if-pre-up.d/wpasupplicant exited with return code 1
Waiting for br0 to get ready (MAXWAIT is 32 seconds).
I'm worried about the wpa_supplicant error. The file is present:
jochus@Bacardi ~ $ ls -al /sbin/wpa_supplicant
-rwxr-xr-x 1 root root 319812 2008-03-12 22:28 /sbin/wpa_supplicant
The output of ifconfig:
jochus@Bacardi ~ $ route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 br0
169.254.0.0 0.0.0.0 255.255.0.0 U 1000 0 0 br0
0.0.0.0 192.168.1.1 0.0.0.0 UG 100 0 0 br0
jochus@Bacardi ~ $ ifconfig
br0 Link encap:Ethernet HWaddr 00:15:00:1f:20:a6
inet addr:192.168.1.111 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::215:ff:fe1f:20a6/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:12 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:720 (720.0 B)
eth0 Link encap:Ethernet HWaddr 00:0a:e4:ae:7e:4c
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:20 Base address:0xc000
eth1 Link encap:Ethernet HWaddr 00:15:00:1f:20:a6
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:5255 errors:12 dropped:12 overruns:0 frame:0
TX packets:466 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:912108 (890.7 KB) TX bytes:113643 (110.9 KB)
Interrupt:21 Memory:c8006000-c8006fff
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1974 errors:0 dropped:0 overruns:0 frame:0
TX packets:1974 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:101385 (99.0 KB) TX bytes:101385 (99.0 KB)
The output of iwconfig of eth1
jochus@Bacardi ~ $ iwconfig eth1
eth1 unassociated ESSID:"Jochus"
Mode:Managed Frequency=2.462 GHz Access Point: Not-Associated
Bit Rate:0 kb/s Tx-Power=20 dBm Sensitivity=8/0
Retry limit:7 RTS thr:off Fragment thr:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:146 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
The output of arp -an:
jochus@Bacardi ~ $ arp -an
? (192.168.1.1) at <incomplete> on br0
next prev parent reply other threads:[~2009-05-04 21:06 UTC|newest]
Thread overview: 47+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-04-27 21:13 [Bridge] Ubuntu: network bridging between wireless and wired connection fails Jochen Hebbrecht
2009-04-27 21:36 ` richardvoigt
2009-04-28 6:44 ` Jochen Hebbrecht
2009-04-28 12:40 ` Ross Vandegrift
2009-04-28 12:52 ` Jochen Hebbrecht
2009-04-28 13:37 ` Ross Vandegrift
2009-04-28 17:36 ` Jochen Hebbrecht
2009-04-28 19:00 ` richardvoigt
2009-04-28 21:16 ` Jochen Hebbrecht
2009-04-28 23:00 ` richardvoigt
2009-04-29 16:16 ` Jochen Hebbrecht
2009-04-29 16:26 ` Ross Vandegrift
2009-04-29 16:40 ` Jochen Hebbrecht
2009-04-29 16:53 ` Ross Vandegrift
2009-04-29 21:21 ` Jochen Hebbrecht
2009-04-30 4:18 ` richardvoigt
2009-04-30 6:30 ` Jochen Hebbrecht
2009-04-30 21:54 ` Nicolas de Pesloüan
2009-05-02 13:15 ` Jochen Hebbrecht
2009-05-03 17:46 ` Nicolas de Pesloüan
2009-05-04 3:59 ` richardvoigt
2009-05-04 19:29 ` Jochen Hebbrecht
2009-05-04 19:28 ` Jochen Hebbrecht
2009-05-04 19:34 ` Nicolas de Pesloüan
2009-05-04 19:42 ` Jochen Hebbrecht
2009-05-04 20:07 ` Nicolas de Pesloüan
2009-05-04 21:06 ` Jochen Hebbrecht [this message]
2009-05-04 23:33 ` richardvoigt
2009-05-05 5:49 ` Nicolas de Pesloüan
2009-05-05 16:59 ` Jochen Hebbrecht
2009-05-05 6:20 ` Nicolas de Pesloüan
2009-05-05 17:01 ` Jochen Hebbrecht
2009-05-05 18:08 ` richardvoigt
2009-05-05 19:19 ` Jochen Hebbrecht
2009-05-05 19:53 ` Jonathan Thibault
2009-05-05 20:52 ` Jochen Hebbrecht
2009-05-05 21:44 ` Nicolas de Pesloüan
2009-05-06 6:57 ` Jochen Hebbrecht
2009-05-06 15:37 ` Jochen Hebbrecht
2009-05-06 16:55 ` Jonathan Thibault
2009-05-09 11:15 ` Jochen Hebbrecht
2009-05-06 16:47 ` Jochen Hebbrecht
2009-05-06 20:07 ` Nicolas de Pesloüan
2009-05-09 11:17 ` Jochen Hebbrecht
2009-05-09 23:30 ` richardvoigt
2009-05-10 15:39 ` Nicolas de Pesloüan
2009-04-29 16:41 ` Jochen Hebbrecht
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=49FF58EC.2090902@gmail.com \
--to=jochenhebbrecht@gmail.com \
--cc=bridge@lists.linux-foundation.org \
--cc=nicolas.2p.debian@free.fr \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.