From: Clyde McPherson <ccmcphe@verizon.net>
To: ath9k-devel@lists.ath9k.org
Subject: [ath9k-devel] SR71C information
Date: Wed, 22 Jul 2009 14:41:37 -0400 [thread overview]
Message-ID: <4A675D61.2080602@verizon.net> (raw)
Here is the information you requested on the Ubiquity SR71C (Cardbus):
lspci:
0d:00.0 Network controller [0280]: Atheros Communications Inc. AR922X
Wireless Network Adapter [168c:0029] (rev 01)
Subsystem: Device [0777:4c05]
Flags: bus master, 66MHz, medium devsel, latency 168, IRQ 20
Memory at 24000000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [44] Power Management version 2
Kernel driver in use: ath9k
Kernel modules: ath9k
Kernel log file during card init:
Jul 20 22:38:26 javalina kernel: [ 156.640166] pci 0000:0d:00.0: reg 10
32bit mmio: [0x000000-0x00ffff]
Jul 20 22:38:26 javalina kernel: [ 156.640280] pci 0000:0d:00.0: PME#
supported from D0 D3hot
Jul 20 22:38:26 javalina kernel: [ 156.640292] pci 0000:0d:00.0: PME#
disabled
Jul 20 22:38:26 javalina kernel: [ 156.819899] ath9k 0000:0d:00.0:
enabling device (0000 -> 0002)
Jul 20 22:38:26 javalina kernel: [ 156.819917] ath9k 0000:0d:00.0: PCI
INT A -> GSI 20 (level, low) -> IRQ 20
Jul 20 22:38:28 javalina kernel: [ 158.384991] ath: EEPROM regdomain: 0x0
Jul 20 22:38:28 javalina kernel: [ 158.384996] ath: EEPROM indicates
default country code should be used
Jul 20 22:38:28 javalina kernel: [ 158.385000] ath: doing EEPROM
country->regdmn map search
Jul 20 22:38:28 javalina kernel: [ 158.385010] ath: country maps to
regdmn code: 0x3a
Jul 20 22:38:28 javalina kernel: [ 158.385015] ath: Country alpha2
being used: US
Jul 20 22:38:28 javalina kernel: [ 158.385019] ath: Regpair used: 0x3a
Jul 20 22:38:28 javalina kernel: [ 158.386393] phy1: Selected rate
control algorithm 'ath9k_rate_control'
Jul 20 22:38:28 javalina kernel: [ 158.389610] cfg80211: Calling CRDA
for country: US
Jul 20 22:38:28 javalina kernel: [ 158.390088] Registered led device:
ath9k-phy1::radio
Jul 20 22:38:28 javalina kernel: [ 158.390212] Registered led device:
ath9k-phy1::assoc
Jul 20 22:38:28 javalina kernel: [ 158.390337] Registered led device:
ath9k-phy1::tx
Jul 20 22:38:28 javalina kernel: [ 158.390455] Registered led device:
ath9k-phy1::rx
Jul 20 22:38:28 javalina kernel: [ 158.390471] phy1: Atheros AR9280
MAC/BB Rev:2 AR5133 RF Rev:d0: mem=0xdffa0000, irq=20
Jul 20 22:38:28 javalina kernel: [ 158.393583] cfg80211: Regulatory
domain changed to country: US
Jul 20 22:38:28 javalina kernel: [ 158.393590] ^I(start_freq - end_freq
@ bandwidth), (max_antenna_gain, max_eirp)
Jul 20 22:38:28 javalina kernel: [ 158.393596] ^I(2402000 KHz - 2472000
KHz @ 40000 KHz), (300 mBi, 2700 mBm)
Jul 20 22:38:28 javalina kernel: [ 158.393602] ^I(5170000 KHz - 5250000
KHz @ 40000 KHz), (300 mBi, 1700 mBm)
Jul 20 22:38:28 javalina kernel: [ 158.393608] ^I(5250000 KHz - 5330000
KHz @ 40000 KHz), (300 mBi, 2000 mBm)
Jul 20 22:38:28 javalina kernel: [ 158.393614] ^I(5490000 KHz - 5710000
KHz @ 40000 KHz), (300 mBi, 2000 mBm)
Jul 20 22:38:28 javalina kernel: [ 158.393619] ^I(5735000 KHz - 5835000
KHz @ 40000 KHz), (300 mBi, 3000 mBm)
Jul 20 22:38:33 javalina kernel: [ 163.301259] ADDRCONF(NETDEV_UP):
wlan1: link is not ready
Kernel log entry reinit and associated:
Jul 20 23:21:28 javalina kernel: [ 2739.124079] pcmcia_socket
pcmcia_socket0: pccard: CardBus card inserted into slot 0
Jul 20 23:21:28 javalina kernel: [ 2739.124162] pci 0000:0d:00.0: reg 10
32bit mmio: [0x000000-0x00ffff]
Jul 20 23:21:28 javalina kernel: [ 2739.124275] pci 0000:0d:00.0: PME#
supported from D0 D3hot
Jul 20 23:21:28 javalina kernel: [ 2739.124287] pci 0000:0d:00.0: PME#
disabled
Jul 20 23:21:28 javalina kernel: [ 2739.124517] ath9k 0000:0d:00.0:
enabling device (0000 -> 0002)
Jul 20 23:21:28 javalina kernel: [ 2739.124535] ath9k 0000:0d:00.0: PCI
INT A -> GSI 20 (level, low) -> IRQ 20
Jul 20 23:21:30 javalina kernel: [ 2740.688524] ath: EEPROM regdomain: 0x0
Jul 20 23:21:30 javalina kernel: [ 2740.688531] ath: EEPROM indicates
default country code should be used
Jul 20 23:21:30 javalina kernel: [ 2740.688536] ath: doing EEPROM
country->regdmn map search
Jul 20 23:21:30 javalina kernel: [ 2740.688543] ath: country maps to
regdmn code: 0x3a
Jul 20 23:21:30 javalina kernel: [ 2740.688549] ath: Country alpha2
being used: US
Jul 20 23:21:30 javalina kernel: [ 2740.688554] ath: Regpair used: 0x3a
Jul 20 23:21:30 javalina kernel: [ 2740.692172] phy3: Selected rate
control algorithm 'ath9k_rate_control'
Jul 20 23:21:30 javalina kernel: [ 2740.697244] Registered led device:
ath9k-phy3::radio
Jul 20 23:21:30 javalina kernel: [ 2740.697306] Registered led device:
ath9k-phy3::assoc
Jul 20 23:21:30 javalina kernel: [ 2740.697350] Registered led device:
ath9k-phy3::tx
Jul 20 23:21:30 javalina kernel: [ 2740.697392] Registered led device:
ath9k-phy3::rx
Jul 20 23:21:30 javalina kernel: [ 2740.697414] phy3: Atheros AR9280
MAC/BB Rev:2 AR5133 RF Rev:d0: mem=0xe0560000, irq=20
Jul 20 23:21:35 javalina kernel: [ 2745.298212] ADDRCONF(NETDEV_UP):
wlan0: link is not ready
Jul 20 23:21:46 javalina kernel: [ 2756.473904] wlan0: deauthenticating
by local choice (reason=3)
Jul 20 23:21:46 javalina kernel: [ 2756.484506] wlan0: direct probe to
AP 00:14:bf:1f:66:14 (try 1)
Jul 20 23:21:46 javalina kernel: [ 2756.486870] wlan0 direct probe responded
Jul 20 23:21:46 javalina kernel: [ 2756.486876] wlan0: authenticate with
AP 00:14:bf:1f:66:14 (try 1)
Jul 20 23:21:46 javalina kernel: [ 2756.488870] wlan0: authenticated
Jul 20 23:21:46 javalina kernel: [ 2756.684082] wlan0: associate with AP
00:14:bf:1f:66:14 (try 1)
Jul 20 23:21:46 javalina kernel: [ 2756.686685] wlan0: RX AssocResp from
00:14:bf:1f:66:14 (capab=0x1 status=0 aid=4)
Jul 20 23:21:46 javalina kernel: [ 2756.686693] wlan0: associated
Jul 20 23:21:46 javalina kernel: [ 2756.686978] ADDRCONF(NETDEV_CHANGE):
wlan0: link becomes ready
Jul 20 23:21:56 javalina kernel: [ 2766.904042] wlan0: no IPv6 routers
present
iwconfig:
iwconfig after association:
wlan0 IEEE 802.11abgn ESSID:"barn_yard"
Mode:Managed Frequency:2.462 GHz Access Point: 00:14:BF:1F:66:14
Bit Rate=11 Mb/s Tx-Power=27 dBmJul 20 23:21:28 javalina
kernel: [ 2739.124079] pcmcia_socket pcmcia_socket0: pccard:
Retry long limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:on
Link Quality=50/70 Signal level=-60 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Thanks
Clyde "Tex" McPherson
next reply other threads:[~2009-07-22 18:41 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-07-22 18:41 Clyde McPherson [this message]
2009-07-22 18:47 ` [ath9k-devel] SR71C information Luis R. Rodriguez
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4A675D61.2080602@verizon.net \
--to=ccmcphe@verizon.net \
--cc=ath9k-devel@lists.ath9k.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.