* LSI SAS2008-based controller does not export disks behind raid
@ 2011-02-17 13:58 Artem Bokhan
0 siblings, 0 replies; only message in thread
From: Artem Bokhan @ 2011-02-17 13:58 UTC (permalink / raw)
To: linux-scsi
Hello.
I have LSI SAS2008-based controller (mpt2sas driver). Old firmware exports disks
behind raid so they could be read by smartmontools, new one does not. Is this
firmware-only issue or behaviour could be forced by driver?
Old behavior:
[...]
Feb 2 23:57:03 ubuntu kernel: [ 3.745023] mpt2sas0: LSISAS2008:
FWVersion(04.00.00.00), ChipRevision(0x02), BiosVersion(07.03.00.00)
Feb 2 23:57:03 ubuntu kernel: [ 3.745028] mpt2sas0:
Protocol=(Initiator,Target), Capabilities=(Raid,TLR,EEDP,Snapshot Buffer,Diag
Trace Buffer,Task Set Full,NCQ)
Feb 2 23:57:03 ubuntu kernel: [ 3.745095] mpt2sas0: sending port enable !!
Feb 2 23:57:03 ubuntu kernel: [ 5.473091] mpt2sas0: host_add:
handle(0x0001), sas_addr(0x50030480004c4df0), phys(8)
Feb 2 23:57:03 ubuntu kernel: [ 7.108617] scsi 7:0:0:0: CD-ROM
TEAC DV-W28S-V D.0A PQ: 0 ANSI: 0
Feb 2 23:57:03 ubuntu kernel: [ 7.119447] sr0: scsi3-mmc drive: 24x/24x
writer dvd-ram cd/rw xa/form2 cdda tray
Feb 2 23:57:03 ubuntu kernel: [ 7.119453] Uniform CD-ROM driver Revision: 3.20
Feb 2 23:57:03 ubuntu kernel: [ 7.119639] sr 7:0:0:0: Attached scsi generic
sg0 type 5
Feb 2 23:57:03 ubuntu kernel: [ 12.707672] mpt2sas0: port enable: SUCCESS
Feb 2 23:57:03 ubuntu kernel: [ 13.086899] scsi 0:1:0:0: Direct-Access
LSI Logical Volume 3000 PQ: 0 ANSI: 6
Feb 2 23:57:03 ubuntu kernel: [ 13.088373] scsi 0:1:0:0: RAID1:
handle(0x0143), wwid(0x0c73dae32c7319bf), pd_count(2), type(SATA)
Feb 2 23:57:03 ubuntu kernel: [ 13.088380] scsi 0:1:0:0: qdepth(128),
tagged(1), simple(1), ordered(0), scsi_level(7), cmd_que(1)
Feb 2 23:57:03 ubuntu kernel: [ 13.088543] sd 0:1:0:0: Attached scsi generic
sg1 type 0
Feb 2 23:57:03 ubuntu kernel: [ 13.088899] sd 0:1:0:0: [sda] 488280064
512-byte logical blocks: (249 GB/232 GiB)
Feb 2 23:57:03 ubuntu kernel: [ 13.089446] sd 0:1:0:0: [sda] Write Protect is
off
Feb 2 23:57:03 ubuntu kernel: [ 13.089685] sd 0:1:0:0: [sda] Write cache:
disabled, read cache: enabled, doesn't support DPO or FUA
Feb 2 23:57:03 ubuntu kernel: [ 13.090558] sda:
Feb 2 23:57:03 ubuntu kernel: [ 13.090770] scsi 0:0:0:0: Direct-Access
ATA WDC WD2502ABYS-0 3B03 PQ: 0 ANSI: 5
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Feb 2 23:57:03 ubuntu kernel: [ 13.091155] scsi 0:0:0:0: SATA:
handle(0x0009), sas_addr(0x4433221102000000), device_name(0x4ee15001ce3badae)
Feb 2 23:57:03 ubuntu kernel: [ 13.091158] scsi 0:0:0:0: SATA:
enclosure_logical_id(0x50030480004c4df0), slot(2)
Feb 2 23:57:03 ubuntu kernel: [ 13.091355] scsi 0:0:0:0: atapi(n), ncq(y),
asyn_notify(n), smart(y), fua(y), sw_preserve(y)
Feb 2 23:57:03 ubuntu kernel: [ 13.091359] scsi 0:0:0:0: qdepth(32),
tagged(1), simple(1), ordered(0), scsi_level(6), cmd_que(1)
Feb 2 23:57:03 ubuntu kernel: [ 13.091430] scsi 0:0:0:0: Attached scsi
generic sg2 type 0
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Feb 2 23:57:03 ubuntu kernel: [ 13.106287] sda1 sda2 <
Feb 2 23:57:03 ubuntu kernel: [ 13.108938] scsi 0:0:1:0: Direct-Access
ATA WDC WD2502ABYS-0 3B03 PQ: 0 ANSI: 5
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Feb 2 23:57:03 ubuntu kernel: [ 13.109311] sda5 >
Feb 2 23:57:03 ubuntu kernel: [ 13.109622] scsi 0:0:1:0: SATA:
handle(0x000a), sas_addr(0x4433221103000000), device_name(0x4ee15001d696030a)
Feb 2 23:57:03 ubuntu kernel: [ 13.109628] scsi 0:0:1:0: SATA:
enclosure_logical_id(0x50030480004c4df0), slot(3)
Feb 2 23:57:03 ubuntu kernel: [ 13.109743] scsi 0:0:1:0: atapi(n), ncq(y),
asyn_notify(n), smart(y), fua(y), sw_preserve(y)
Feb 2 23:57:03 ubuntu kernel: [ 13.109747] scsi 0:0:1:0: qdepth(32),
tagged(1), simple(1), ordered(0), scsi_level(6), cmd_que(1)
Feb 2 23:57:03 ubuntu kernel: [ 13.109865] scsi 0:0:1:0: Attached scsi
generic sg3 type 0
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Feb 2 23:57:03 ubuntu kernel: [ 13.110295] sd 0:1:0:0: [sda] Attached SCSI disk
New behavior:
Feb 3 10:50:11 ubuntu kernel: [ 3.684393] mpt2sas0: LSISAS2008:
FWVersion(08.00.00.00), ChipRevision(0x02), BiosVersion(07.15.00.00)
Feb 3 10:50:11 ubuntu kernel: [ 3.684397] mpt2sas0:
Protocol=(Initiator,Target), Capabilities=(Raid,TLR,EEDP,Snapshot Buffer,Diag
Trace Buffer,Task Set Fu
ll,NCQ)
Feb 3 10:50:11 ubuntu kernel: [ 3.684462] mpt2sas0: sending port enable !!
Feb 3 10:50:11 ubuntu kernel: [ 5.198735] mpt2sas0: host_add:
handle(0x0001), sas_addr(0x50030480004c4df0), phys(8)
Feb 3 10:50:11 ubuntu kernel: [ 8.256411] scsi 7:0:0:0: CD-ROM
TEAC DV-W28S-V D.0A PQ: 0 ANSI: 0
Feb 3 10:50:11 ubuntu kernel: [ 8.269509] sr0: scsi3-mmc drive: 24x/24x
writer dvd-ram cd/rw xa/form2 cdda tray
Feb 3 10:50:11 ubuntu kernel: [ 8.269514] Uniform CD-ROM driver Revision: 3.20
Feb 3 10:50:11 ubuntu kernel: [ 8.269706] sr 7:0:0:0: Attached scsi generic
sg0 type 5
Feb 3 10:50:11 ubuntu kernel: [ 11.061165] mpt2sas0: port enable: SUCCESS
Feb 3 10:50:11 ubuntu kernel: [ 11.061688] scsi 0:1:0:0: Direct-Access
LSI Logical Volume 3000 PQ: 0 ANSI: 6
Feb 3 10:50:11 ubuntu kernel: [ 11.062438] scsi 0:1:0:0: RAID1:
handle(0x011e), wwid(0x0c73dae32c7319bf), pd_count(2), type(SATA)
Feb 3 10:50:11 ubuntu kernel: [ 11.062444] scsi 0:1:0:0: qdepth(128),
tagged(1), simple(1), ordered(0), scsi_level(7), cmd_que(1)
Feb 3 10:50:11 ubuntu kernel: [ 11.062602] sd 0:1:0:0: Attached scsi generic
sg1 type 0
Feb 3 10:50:11 ubuntu kernel: [ 11.063018] sd 0:1:0:0: [sda] 488280064
512-byte logical blocks: (249 GB/232 GiB)
Feb 3 10:50:11 ubuntu kernel: [ 11.063312] sd 0:1:0:0: [sda] Write Protect is
off
Feb 3 10:50:11 ubuntu kernel: [ 11.063450] sd 0:1:0:0: [sda] Write cache:
disabled, read cache: enabled, doesn't support DPO or FUA
Feb 3 10:50:11 ubuntu kernel: [ 11.063728] sda: sda1 sda2 < sda5 >
Feb 3 10:50:11 ubuntu kernel: [ 11.087127] sd 0:1:0:0: [sda] Attached SCSI disk
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2011-02-17 13:58 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2011-02-17 13:58 LSI SAS2008-based controller does not export disks behind raid Artem Bokhan
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.