Re: [PATCH 1/2] powerpc: document the FSL MPIC message register binding

[Meador Inge <meador_inge@mentor.com>]

On 04/19/2011 01:33 PM, Scott Wood wrote:
> On Tue, 19 Apr 2011 13:26:26 -0500
> Meador Inge <meador_inge@mentor.com> wrote:
> 
>> On 04/19/2011 12:52 PM, Scott Wood wrote:
>>> On Tue, 19 Apr 2011 11:59:34 -0500
>>> Meador Inge <meador_inge@mentor.com> wrote:
>>>
>>>>  Aliases are of the form 'msgr-block<n>',
>>>> +    where <n> is an integer specifying the block's number.  Numbers shall start
>>>> +    at 0.
>>>
>>> The hw docs refer to "group A" and "group B", not "block 0" and "block 1".
>>>
>>> Plus, I'd put "mpic-" in the alias name.
>>
>> Are you suggesting that the alias should be called: 'mpic-groupA',
>> 'mpic-groupB', 'mpic-groupC', etc... ?
> 
> I was thinking something like "mpic-msgr-group-a", "mpic-msgr-group-b" --
> though if you want to use numbers instead to more easily map to potential
> APIs, that's OK.
> 

Hmmm ...  In the MPC8572E and P1022DS manuals I don't see the terminology
group used for message registers.  The MPIC global timers on the other hand
do use group A and group B.  I will definitely add the 'mpic-' prefix, but
unless I am looking in the wrong place in the manuals, then I am not so
sure there are MPIC message register groups.  As a side note,
the term "register block" pops up in a few places not related to
message registers.

If you feel like group is a more idiomatic term, I can change it.

-- 
Meador Inge     | meador_inge AT mentor.com
Mentor Embedded | http://www.mentor.com/embedded-software