[U-Boot] mx31: NAND_SPL boot question for TT-01

[U-Boot] mx31: NAND_SPL boot question for TT-01

[Helmut Raiger]

Hi (Stefano),

     just a short question. I'd like to add NAND boot to the board 
support of our TT-01.
I checked out the mx31pdk code and also found something in doc/README.SPL
which does not seem to correspond.

Before I head into the wrong direction again, is the mx31pdk implementation
still hip?

Thx, Helmut


--
Scanned by MailScanner.

[U-Boot] mx31: NAND_SPL boot question for TT-01

[Stefano Babic]

On 10/31/2011 06:01 PM, Helmut Raiger wrote:
> Hi (Stefano),
> 
>     just a short question. I'd like to add NAND boot to the board
> support of our TT-01.
> I checked out the mx31pdk code and also found something in doc/README.SPL
> which does not seem to correspond.

Right. A lot of work was done recently, and now there is a common SPL
framework in u-boot. The README.spl refers to the new stuff.

Before of that, booting from NAND was done in a different manner. This
is what you find under board/freescale/mx31pdk. The mx31pdk is booting
with the old mechanism.

New boards must implement the SPL according to the new framework, using
CONFIG_SPL and setting the SPL configuration in the board configuration
file. I am expecting

Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================