problems getting v4l to start

problems getting v4l to start

[Ralf Moeller]

Hi,

I tried to compile v4l media_build in case of getting a dvb-t card to run.
(it uses saa7134)

when i made "make install" and reboot, it says the module saa7134 have
unknown symbols.

then I tried it by removing older dvb/v4l support from my customkernel 
(2.6.37.2)
rebuild media_build again, but same problem. modprobe says error about 
unknown
symbols and with dmesg there is written "saa7134: unknown parameter index"

what went wrong ?
is there help available ?

kind regards,
ralf moeller

-- 
MOELLER IT ELECTRONICS
Ralf Moeller
SchlachthofStr. 12A
D-27576 Bremerhaven
Telefon : +49-471-3095737
Mailbox : +49-471-3069320
Mobil   : +49-178-1483064
http://www.mitlab.de

Re: problems getting v4l to start

[Tim Draper]

On 17 November 2011 12:27, Ralf Moeller <ralf.moeller@mitlab.de> wrote:
> Hi,
>
> I tried to compile v4l media_build in case of getting a dvb-t card to run.
> (it uses saa7134)
>
> when i made "make install" and reboot, it says the module saa7134 have
> unknown symbols.
>
> then I tried it by removing older dvb/v4l support from my customkernel
> (2.6.37.2)
> rebuild media_build again, but same problem. modprobe says error about
> unknown
> symbols and with dmesg there is written "saa7134: unknown parameter index"
>
> what went wrong ?
> is there help available ?
>
> kind regards,
> ralf moeller




have you tried following this link:
http://linuxtv.org/wiki/index.php/How_to_Obtain,_Build_and_Install_V4L-DVB_Device_Drivers