Re: Driver support ...

Re: Driver support ...

[Arend van Spriel]

On 11/20/2011 03:17 AM, michael caron couturier wrote:
> Hello,
> 
> I got to find a decent drivers for my needs on linux, I use Archlinux, here's my lscpi output :
> 
> 02:00.0 Network controller: Broadcom Corporation BCM4313 802.11b/g/n Wireless LAN Controller (rev 01)
> 
> I connect to a wifi adhoc from my 2nd laptop, it would be helpful to be able to make an adhoc connection also, I would need monitor mode for security test if possible, that would remove me the need of my bulky yagi usb antenna ...
> 
> Drivers or tools relatives to broadcom : b43, b43-fwcutter, b43-firmware-installer, wl, sta, brcm80211 ...
> 
> Mike

If adhoc is than you can either use proprietary wl driver [1] or b43
driver [2]. Both may be available in ArchLinux.

Gr. AvS

[1] http://www.broadcom.com/support/802.11/linux_sta.php
[2] http://wireless.kernel.org/en/users/Drivers/b43

driver support ?

[Yu Bo-BOYU1]

I wish to port the linux to another custom board with 7410 + mpc107 with
TI's 752 uart chip and national semi's dp83815 integrated mac and phy.

1. Does anyone know if these uart driver and ethernet driver exist in
current
release of Monta Vista preview 2.1 or ELDK ?

2. Where should I look at if I have to modify the uart driver ? I guess this
uart
should be easily ported.

Right now after I downloaded the built linux image, I could not see anything
on serial port.

Thanks.

Bo Yu
Motorola, GTSS
1-817-245-6725


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/

Re: driver support ?

[Wolfgang Denk]

In message <0B0A39652BB0D411BCCF00508B9512EC08AEB515@tx14exm05.ftw.mot.com> you wrote:
>
> I wish to port the linux to another custom board with 7410 + mpc107 with
> TI's 752 uart chip and national semi's dp83815 integrated mac and phy.
>
> 1. Does anyone know if these uart driver and ethernet driver exist in
> current
> release of Monta Vista preview 2.1 or ELDK ?

Please note that the ELDK is primarily an Embedded Linux  Development
Kit; it ships with a 2.4.4 kernel, which is very reliable and running
really  well, but for new projects you should probalby base your work
on the linuxppc_2_4_devel kernel instead.

Neither the 752 nor the DP83815 will run out  of  the  box  with  our
2.4.4 kernel.

> 2. Where should I look at if I have to modify the uart driver ? I guess this
> uart
> should be easily ported.

Umm... I don't understand the  question?  You  should  look  at  your
driver's source code, of course ;-)

> Right now after I downloaded the built linux image, I could not see anything
> on serial port.

Attach your BDI2000, and start GDB.

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
The only way to get rid of a temptation is to yield to it.
                                                        - Oscar Wilde

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/