Re: [PATCH v2 09/10] arm/dts: omap3-beagle: Add twl4030 and i2c EEPROM

["Cousson, Benoit" <b-cousson@ti.com>]

On 1/10/2012 12:24 AM, Tabi Timur-B04825 wrote:
> On Fri, Dec 9, 2011 at 8:02 AM, Benoit Cousson<b-cousson@ti.com>  wrote:
>>
>> +       eeprom@50 {
>> +               compatible = "ti,eeprom";
>> +               reg =<0x50>;
>> +       };
>
> Why is this "ti,"?  For EDID, isn't the I2C device actually on the
> monitor itself, and DVI cable just connects to the I2C bus?

Yes, in fact I didn't know what to put here, since I do not know what 
kind of eeprom the monitor will use.

And then I realized that the i2c driver is using the compatible name 
without the prefix, so any prefix can be used there...
OK, that's maybe not a very valid reason... but I did not find any 
better prefix at that time:-)

> The reason I ask is that I'm trying to do the same thing for a PowerPC
> board.  I need to defined an EDID I2C node.

Well, this seems to be generic i2c eeprom, so maybe a "ddc," prefix or 
"edid," will be a little bit better.

If later, we want to access that node from the display driver, we can 
just add a phandle to the node's label: "edid-eeprom: eeprom@50:"

Regards,
Benoit