[PATCH 03/12] ARM: at91/USB host: specify and handle properly vbus_pin_active_low

[sshtylyov@mvista.com (Sergei Shtylyov)]

Hello.

On 29-03-2012 17:27, Nicolas Ferre wrote:

> Due to an error while handling vbus_pin_active_low in ohci-at91 driver,
> the specification of this property was not good in devices/board files.

> Signed-off-by: Nicolas Ferre<nicolas.ferre@atmel.com>
> Acked-by: Jean-Christophe PLAGNIOL-VILLARD<plagnioj@jcrosoft.com>
> Cc: stable<stable@vger.kernel.org>          [3.2+]
> ---
>   arch/arm/mach-at91/at91sam9263_devices.c |    3 ++-
>   arch/arm/mach-at91/at91sam9g45_devices.c |    6 ++++--
>   arch/arm/mach-at91/board-sam9263ek.c     |    1 +
>   arch/arm/mach-at91/board-sam9m10g45ek.c  |    1 +
>   4 files changed, 8 insertions(+), 3 deletions(-)
>
> diff --git a/arch/arm/mach-at91/at91sam9263_devices.c b/arch/arm/mach-at91/at91sam9263_devices.c
> index 53688c4..5cdca89d 100644
> --- a/arch/arm/mach-at91/at91sam9263_devices.c
> +++ b/arch/arm/mach-at91/at91sam9263_devices.c
> @@ -72,7 +72,8 @@ void __init at91_add_device_usbh(struct at91_usbh_data *data)
>   	/* Enable VBus control for UHP ports */
>   	for (i = 0; i<  data->ports; i++) {
>   		if (gpio_is_valid(data->vbus_pin[i]))
> -			at91_set_gpio_output(data->vbus_pin[i], 0);
> +			at91_set_gpio_output(data->vbus_pin[i],
> +					     data->vbus_pin_active_low[i] ^ 0);

    Note that XOR with 0 is a nop, left operand doesn't change its value.

WBR, Sergei