Re: [PATCH v2 01/12] ARM: Orion: DT support for IRQ and GPIO Controllers

[Sebastian Hesselbarth <sebastian.hesselbarth-gM/Ye1E23mwN+BqQ9rBEUg@public.gmane.org>]

On 07/05/2012 03:08 PM, Andrew Lunn wrote:
> The issue is knowing what IRQ number to use for the secondary
> interrupts.
>
> Orion use generic chip interrupts, both for the main interrupts and
> the GPIO interrupts. This does not yet support irq domain, so i have
> to layer a legacy domain on top. The legacy domain needs to know the
> first IRQ and the number of IRQs. For the primary IRQs that is
> easy. However, GPIO IRQ is not so easy, it depends on how many primary
> IRQs there are. This is not fixed. Orion5x has 32, Dove 64, kirkwood,
> 64, and mv78xx0 has 96. I need to know this number when adding the
> GPIO secondary IRQ legacy domain. By calling orion_gpio_of_init() in
> the orion_add_irq_domain() i have this number to hand. If i used to
> entries in the match table, i would have to put this number into some
> global variable, or somehow ask the IRQ subsystem what the next free
> IRQ number is.

Andrew,

is it possible to group all gpio banks into one DT description?
For mach-dove it could be something like:

gpio: gpio-controller {
	compatible = "marvell, orion-gpio";
	...

	bank0@d0400 {
		reg = <0xd0400 0x40>;
		ngpio = <8>;
		mask-offset = <0>;
		interrupts = <12>;
	};

	bank1@d0400 {
		reg = <0xd0400 0x40>;
		ngpio = <8>;
		mask-offset = <8>;
		interrupts = <13>;
	};

	...

	bank4@d0420 {
		reg = <0xd0420 0x40>;
		ngpio = <32>;
		interrupts = <61>;
	};		

	bank5@e8400 {
		reg = <0xe8400 0x20>;
		ngpio = <8>;
		marvell,orion-gpio-output-only;
	};		
};

This would have the advantage that DT describes gpio-to-irq dependencies.
Moreover, nodes that reference gpios can do gpios = <&gpio 71 0>; instead of
gpios = <&gpio3 7 0>;

Sebastian