[GIT PULL] io.h clean-up for PCI

[robherring2@gmail.com (Rob Herring)]

On 07/24/2012 07:43 AM, Arnd Bergmann wrote:
> On Tuesday 24 July 2012, Rob Herring wrote:
>>> --- a/arch/arm/mach-iop13xx/include/mach/iop13xx.h
>>> +++ b/arch/arm/mach-iop13xx/include/mach/iop13xx.h
>>> @@ -95,7 +95,6 @@ extern unsigned long get_iop_tick_rate(void);
>>>  /* PCI-E ranges */
>>>  #define IOP13XX_PCIE_LOWER_IO_PA              0xfffd0000UL
>>>  #define IOP13XX_PCIE_LOWER_IO_BA              0x0UL  /* OIOTVR */
>>> -#define IOP13XX_PCIE_LOWER_IO_BA              0x10000UL
>>
>> This means we have PCIE and PCIX buses both using i/o bus addresses
>> starting at 0x0. We can't have that, right?
>>
>> The requested resource won't match either as the resource start address
>> is bus_nr * 64K.
> 
> Well, this is the number that gets written into the outbound
> translation window register, which has to be zero AFAICT.
> 
> The PCI device you plug into the bus will always see its io
> ports as being between zero and 65536 -- the part that
> stays at 0x10000UL is the offset address that we use in Linux
> to give it a unique address in the virtual address space
> window we use to cover all the io port ranges.
> 
> The io_offset still gets set to 0x10000, so this number always
> gets added and subtracted when converting between Linux port
> numbers and bus-specific port numbers.

I don't think this is going to work right with the orion family. They
set the 2nd+ buses to some non-zero bus value.

	{ 0, KIRKWOOD_PCIE_IO_PHYS_BASE, KIRKWOOD_PCIE_IO_SIZE,
	  TARGET_PCIE, ATTR_PCIE_IO, KIRKWOOD_PCIE_IO_BUS_BASE

This is 0.

	},
	{ 1, KIRKWOOD_PCIE_MEM_PHYS_BASE, KIRKWOOD_PCIE_MEM_SIZE,
	  TARGET_PCIE, ATTR_PCIE_MEM, KIRKWOOD_PCIE_MEM_BUS_BASE
	},
	{ 2, KIRKWOOD_PCIE1_IO_PHYS_BASE, KIRKWOOD_PCIE1_IO_SIZE,
	  TARGET_PCIE, ATTR_PCIE1_IO, KIRKWOOD_PCIE1_IO_BUS_BASE

This was 0x100000 and is now 0x10000.

	},
	{ 3, KIRKWOOD_PCIE1_MEM_PHYS_BASE, KIRKWOOD_PCIE1_MEM_SIZE,
	  TARGET_PCIE, ATTR_PCIE1_MEM, KIRKWOOD_PCIE1_MEM_BUS_BASE
	},

If we change all these to 0, then I need to go back thru all the platforms.

Rob