Re: [Qemu-devel] [PATCH] MIPS: Correct FCR0 initialization

[Phil Staub <phils@windriver.com>]

On 08/09/2012 03:09 PM, Maciej W. Rozycki wrote:
> On Thu, 9 Aug 2012, Phil Staub wrote:
>
>>>>>> For this purpose the usual approach is to follow up to the patch
>>>>>> mail saying "Ping" and giving a url to the patch in patchwork,
>>>>>> like this one:
>>>>>> http://patchwork.ozlabs.org/patch/163705/
>>>>>>
>>>>>> Eventually somebody will take pity on it and apply it, but
>>>>>> it does require a bit more persistence than for more actively
>>>>>> maintained areas of the codebase.
>>>>>
>>>>> Thanks, applied.
>>>
>>>> Thank you!
>>>
>>> Maciej submitted some other MIPS patches at about the same time:
>>> http://patchwork.ozlabs.org/project/qemu-devel/list/?submitter=4977
>>> at least some of which got reviewed by Richard Henderson and are
>>> therefore good candidates to get committed, if you can fish them out
>>> of the list and ping them...
>>
>> Sounds like a plan. I'll give it a go. May not be today, but soon.
>
>   Excellent, thanks, I've been just about to get back to them after a long
> distraction.  I should have something to add and to address Richard's
> comments tomorrow or early next week.  If resending patches helps, I can
> certainly do that too -- in any case no pings or such stuff from me
> usually does not mean that I am dead, but only that I've been pulled away
> to something else.

I can relate! :-)

Phil

>
>    Maciej
>
>


-- 
Phil Staub, Senior Member of Technical Staff, Wind River
Direct: 702.290.0470 Fax: 702.982.0085