[U-Boot] [PATCH 1/6] h2200: Add support for iPAQ h2200

["Łukasz Dałek" <luk0104@gmail.com>]

On 22.09.2012 20:37, Marek Vasut wrote:
> Dear ?ukasz Da?ek,
>
>> On 22.09.2012 20:21, Marek Vasut wrote:
>>>>>>>>>> +{
>>>>>>>>>> +	writel(val, addr);
>>>>>>>>>> +	asm volatile("" : : : "memory");
>>>>>>>>>> +	readl(addr);
>>>>>>>>>> +	asm volatile("" : : : "memory");
>>>>>>>>>> +}
>>>>>>>>>> +
>>>>>>>>>> +static void h2200_pxa2xx_dram_init(void)
>>>>>>>>> Why do you duplicate it ?!
>>>>>>>>>
>>>>>>>>> [...]
>>>>>>>> Because code in pxa2xx.c disable and then re-enable memory.
>>>>>>>> And u-boot is executed from memory (1st stage bootloder
>>>>>>>> copied it there).
>>>>>>> So don't reinit the memory at all, just skip this whole part.
>>>>>> 1st stage loader doesn't init everything (for example MSC).
>>>>> So I checked ... every board calls the dram init on it's own in
>>>>> dram_init() ... so just don't do that.
>>>> Do what? Don't call modified pxa2xx_dram_init?
>>> What exactly do you need to do ? What registers do you need to set ? How
>>> come the bootloader kick dram in, but won't configure MSC ?
>>>
>>> Split out the MSC config and memory config maybe ?
>> Ok, I will rewrite that.
> Just pull it out, but make sure you don't break the other boards ...

I was only thinking about my board...

?ukasz Da?ek