Re: [Qemu-devel] [PATCH] PIIX3: reset the VM when the Reset Control Register's RCPU bit gets set

[Laszlo Ersek <lersek@redhat.com>]

On 01/15/13 17:53, Paolo Bonzini wrote:
> Il 15/01/2013 00:47, Laszlo Ersek ha scritto:
>> @@ -442,12 +455,14 @@ static void piix3_reset(void *opaque)
>>      pci_conf[0xae] = 0x00;
>>  
>>      d->pic_levels = 0;
>> +    d->rcr = 0;
>>  }
>>  
>>  static int piix3_post_load(void *opaque, int version_id)
>>  {
>>      PIIX3State *piix3 = opaque;
>>      piix3_update_irq_levels(piix3);
>> +    piix3->rcr &= 2; /* keep System Reset type only */
>>      return 0;
>>  }
>>  
>> @@ -464,7 +479,7 @@ static void piix3_pre_save(void *opaque)
>>  
>>  static const VMStateDescription vmstate_piix3 = {
>>      .name = "PIIX3",
>> -    .version_id = 3,
>> +    .version_id = 4,
>>      .minimum_version_id = 2,
>>      .minimum_version_id_old = 2,
>>      .post_load = piix3_post_load,
>> @@ -473,15 +488,46 @@ static const VMStateDescription vmstate_piix3 = {
>>          VMSTATE_PCI_DEVICE(dev, PIIX3State),
>>          VMSTATE_INT32_ARRAY_V(pci_irq_levels_vmstate, PIIX3State,
>>                                PIIX_NUM_PIRQS, 3),
>> +        VMSTATE_UINT8_V(rcr, PIIX3State, 4),
>>          VMSTATE_END_OF_LIST()
>>      }
> 
> It would be nice to put this in a subsection, since it should be almost
> always 0.

OK, "docs/migration.txt" seems to explain subsections nicely. I'll try
to figure it out. I agree that rcr will be almost always 0 and should
not impede newer-to-older migration if possible.

> Otherwise, the patch looks good.

Thanks for the review!
Laszlo