Re: initrd-xxx.img create dracut not correct

[Harald Hoyer <harald-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org>]

Am 12.03.2013 02:14, schrieb yeyouqun:
> 于 2013-3-11 17:31, Harald Hoyer 写道:
>> Am 10.03.2013 10:29, schrieb yeyouqun:
>>> 于 2013-3-8 15:02, Harald Hoyer 写道:
>>>> Am 08.03.2013 05:11, schrieb yeyouqun:
>>>>> Recently I upgraded linux kernel to 3.6.10 and upgrade dracut version to 024,
>>>>> system starts up OK on 3.6.10. But when I upgraded kernel from 3.6.10 to
>>>>> 3.8.2,
>>>>> dracut failed to start up the system. Message when start up reads:
>>>>>
>>>>> ......
>>>>>      dracut: dracut-dracut-024-
>>>>>       rpcbind: cannot create socket for udp6
>>>>>       rpcbind: cannot create socket for tcp6
>>>>>       mount: unknoun filesys
>>>>>       udev: starting version 147
>>>>>       systend-udevd (139): /proc/139/oom_adj is deprecated, please use
>>>>>       /proc/139/oom_score_adj instead.
>>>>>       dracut Warning: Could not boot.
>>>>>       dracut Warning: Could not boot.
>>>>>       Dropping to debug shell.
>>>>>       /bin/sh: can't access tty; job control turned off
>>>>> ......
>>>>>
>>>>> But when I unpack the initrd-3.8.2.img, the /lib/modules directory shows as
>>>>> below:
>>>>>
>>>>> modules ---- 3.8.2
>>>>>            |
>>>>>            |__ 3.6.10
>>>>>
>>>>> all the kernel modules reside in "3.6.10" directory and other files, such as
>>>>> "modules.dep" and etc. reside in 3.8.2, I think this is the reason why system
>>>>> can't start up.
>>>>>
>>>>> I upgraded kernel by the steps as(in kernel source tree of 3.8.2):
>>>>>
>>>>>       make
>>>>>       make modules_install
>>>>>       make install
>>>>>
>>>>> Any one can tell how to fix this behavior of dracut?
>>>> What's the output of:
>>> output is two big, I appende it.
>>>> # dracut --debug test.img 3.8.2
>> /usr/lib/dracut/dracut-functions.sh@1377(dracut_kernel_post): xargs -r modprobe
>> -a -d / --ignore-install --show-depends --set-version 3.8.2
>> /usr/lib/dracut/dracut-functions.sh@1382(dracut_kernel_post): [[ insmod =
>> insmod ]]
>> /usr/lib/dracut/dracut-functions.sh@1383(dracut_kernel_post): echo
>> ///lib/modules/3.6.10/kernel/arch/x86/crypto/crc32c-intel.ko
>>
>>
>> This looks fishy...
>>
>>
>> What is the output of:
>>
>> # modprobe -a --ignore-install --show-depends --set-version 3.8.2 xor
>>
> [root@localhost mnt]# modprobe -a --ignore-install --show-depends --set-version
> 3.8.2 xor
> insmod /lib/modules/3.8.2/kernel/crypto/xor.ko

and what is the output of:

# modprobe -a -d / --ignore-install --show-depends --set-version 3.8.2 xor