Re: [PATCH 4/6] arm: mach-omap2: remove "OMAP_DEVICE_NO_IDLE_ON_SUSPEND" check

[Sourav Poddar <sourav.poddar@ti.com>]

On Thursday 18 April 2013 11:35 PM, Kevin Hilman wrote:
> Sourav Poddar<sourav.poddar@ti.com>  writes:
>
>> Remove the "OMAP_DEVICE_NO_IDLE_ON_SUSPEND" check, since UART was the only one making
>> use of it. Now serial core/driver takes care of the case when "no_console_suspend"
>> is used in the bootargs and you need to keep the clock enable for console even while suspend.
>>
>> Signed-off-by: Sourav Poddar<sourav.poddar@ti.com>
> NAK.  This patch will break many things...
>
>> ---
>>   arch/arm/mach-omap2/omap_device.c |    7 +------
>>   1 files changed, 1 insertions(+), 6 deletions(-)
>>
>> diff --git a/arch/arm/mach-omap2/omap_device.c b/arch/arm/mach-omap2/omap_device.c
>> index 381be7a..d6dce8f 100644
>> --- a/arch/arm/mach-omap2/omap_device.c
>> +++ b/arch/arm/mach-omap2/omap_device.c
>> @@ -620,11 +620,8 @@ static int _od_suspend_noirq(struct device *dev)
>>   	ret = pm_generic_suspend_noirq(dev);
>>
>>   	if (!ret&&  !pm_runtime_status_suspended(dev)) {
>> -		if (pm_generic_runtime_suspend(dev) == 0) {
>> -			if (!(od->flags&  OMAP_DEVICE_NO_IDLE_ON_SUSPEND))
>> -				omap_device_idle(pdev);
> Why did you remove the omap_device_idle() here?
This patch is used along with patch3 to get rid of the issue. I posted 
them as a
seperate patch beacuse of the subject line as one goes under drivers/* 
and the other
arm/mach-omap2/*..

This check was only valid for UART, and if od->flags is set to the
"OMAP_DEVICE_NO_IDLE_ON_SUSPEND" flag, then UART will not be idled. But now,
we no longer depend on od->flag value to prevent idling of our console 
UART as the
prepare/complete apis will take care of them.

>> +		if (pm_generic_runtime_suspend(dev) == 0)
>>   			od->flags |= OMAP_DEVICE_SUSPENDED;
>> -		}
>>   	}
>>
>>   	return ret;
>> @@ -638,8 +635,6 @@ static int _od_resume_noirq(struct device *dev)
>>   	if ((od->flags&  OMAP_DEVICE_SUSPENDED)&&
>>   	!pm_runtime_status_suspended(dev)) {
>>   		od->flags&= ~OMAP_DEVICE_SUSPENDED;
>> -		if (!(od->flags&  OMAP_DEVICE_NO_IDLE_ON_SUSPEND))
>> -			omap_device_enable(pdev);
> And the _enable() here?
>
>>   		pm_generic_runtime_resume(dev);
>>   	}
> Note that the check is for when the flag is *not* set, so this patch
> changes behavior for all the drivers that do not use
> _NO_IDLE_ON_SUSPEND.  I think that's the opposite of what you intended.
>
> Kevin