* [ath9k-devel] AR9580/90
@ 2013-07-08 13:29 Daniel Wunderlich
2013-07-09 7:10 ` Matthias May
0 siblings, 1 reply; 2+ messages in thread
From: Daniel Wunderlich @ 2013-07-08 13:29 UTC (permalink / raw)
To: ath9k-devel
Hi all,
could anyone provide the iw list output of an AR9580 oder AR9590 chipset?
Thanks in advance, Daniel
^ permalink raw reply [flat|nested] 2+ messages in thread
* [ath9k-devel] AR9580/90
2013-07-08 13:29 [ath9k-devel] AR9580/90 Daniel Wunderlich
@ 2013-07-09 7:10 ` Matthias May
0 siblings, 0 replies; 2+ messages in thread
From: Matthias May @ 2013-07-09 7:10 UTC (permalink / raw)
To: ath9k-devel
On 08/07/13 15:29, Daniel Wunderlich wrote:
> Hi all,
>
> could anyone provide the iw list output of an AR9580 oder AR9590 chipset?
>
> Thanks in advance, Daniel
>
> _______________________________________________
> ath9k-devel mailing list
> ath9k-devel at lists.ath9k.org
> https://lists.ath9k.org/mailman/listinfo/ath9k-devel
This is with the country code CH
Wiphy phy0
max # scan SSIDs: 4
max scan IEs length: 2257 bytes
Coverage class: 0 (up to 0m)
Device supports RSN-IBSS.
Supported Ciphers:
* WEP40 (00-0f-ac:1)
* WEP104 (00-0f-ac:5)
* TKIP (00-0f-ac:2)
* CCMP (00-0f-ac:4)
* CMAC (00-0f-ac:6)
Available Antennas: TX 0x7 RX 0x7
Configured Antennas: TX 0x7 RX 0x7
Supported interface modes:
* IBSS
* managed
* AP
* AP/VLAN
* WDS
* monitor
* mesh point
* P2P-client
* P2P-GO
Band 1:
Capabilities: 0x11ef
RX LDPC
HT20/HT40
SM Power Save disabled
RX HT20 SGI
RX HT40 SGI
TX STBC
RX STBC 1-stream
Max AMSDU length: 3839 bytes
DSSS/CCK HT40
Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
Minimum RX AMPDU time spacing: 8 usec (0x06)
HT TX/RX MCS rate indexes supported: 0-23
Bitrates (non-HT):
* 1.0 Mbps
* 2.0 Mbps (short preamble supported)
* 5.5 Mbps (short preamble supported)
* 11.0 Mbps (short preamble supported)
* 6.0 Mbps
* 9.0 Mbps
* 12.0 Mbps
* 18.0 Mbps
* 24.0 Mbps
* 36.0 Mbps
* 48.0 Mbps
* 54.0 Mbps
Frequencies:
* 2412 MHz [1] (20.0 dBm)
* 2417 MHz [2] (20.0 dBm)
* 2422 MHz [3] (20.0 dBm)
* 2427 MHz [4] (20.0 dBm)
* 2432 MHz [5] (20.0 dBm)
* 2437 MHz [6] (20.0 dBm)
* 2442 MHz [7] (20.0 dBm)
* 2447 MHz [8] (20.0 dBm)
* 2452 MHz [9] (20.0 dBm)
* 2457 MHz [10] (20.0 dBm)
* 2462 MHz [11] (20.0 dBm)
* 2467 MHz [12] (20.0 dBm)
* 2472 MHz [13] (20.0 dBm)
* 2484 MHz [14] (disabled)
Band 2:
Capabilities: 0x11ef
RX LDPC
HT20/HT40
SM Power Save disabled
RX HT20 SGI
RX HT40 SGI
TX STBC
RX STBC 1-stream
Max AMSDU length: 3839 bytes
DSSS/CCK HT40
Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
Minimum RX AMPDU time spacing: 8 usec (0x06)
HT TX/RX MCS rate indexes supported: 0-23
Bitrates (non-HT):
* 6.0 Mbps
* 9.0 Mbps
* 12.0 Mbps
* 18.0 Mbps
* 24.0 Mbps
* 36.0 Mbps
* 48.0 Mbps
* 54.0 Mbps
Frequencies:
* 5180 MHz [36] (20.0 dBm)
* 5200 MHz [40] (20.0 dBm)
* 5220 MHz [44] (20.0 dBm)
* 5240 MHz [48] (20.0 dBm)
* 5260 MHz [52] (20.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5280 MHz [56] (20.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5300 MHz [60] (20.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5320 MHz [64] (20.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5500 MHz [100] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5520 MHz [104] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5540 MHz [108] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5560 MHz [112] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5580 MHz [116] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5600 MHz [120] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5620 MHz [124] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5640 MHz [128] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5660 MHz [132] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5680 MHz [136] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5700 MHz [140] (24.0 dBm) (radar detection)
DFS state: usable (for 24 sec)
* 5745 MHz [149] (disabled)
* 5765 MHz [153] (disabled)
* 5785 MHz [157] (disabled)
* 5805 MHz [161] (disabled)
* 5825 MHz [165] (disabled)
Supported commands:
* new_interface
* set_interface
* new_key
* start_ap
* new_station
* new_mpath
* set_mesh_config
* set_bss
* authenticate
* associate
* deauthenticate
* disassociate
* join_ibss
* join_mesh
* remain_on_channel
* set_tx_bitrate_mask
* frame
* frame_wait_cancel
* set_wiphy_netns
* set_channel
* set_wds_peer
* tdls_mgmt
* tdls_oper
* probe_client
* set_noack_map
* register_beacons
* start_p2p_device
* Unknown command (92)
* connect
* disconnect
Supported TX frame types:
* IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0
0xb0 0xc0 0xd0 0xe0 0xf0
* managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90
0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0
0xb0 0xc0 0xd0 0xe0 0xf0
* AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90
0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* mesh point: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80
0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80
0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90
0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* P2P-device: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80
0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
Supported RX frame types:
* IBSS: 0x40 0xb0 0xc0 0xd0
* managed: 0x40 0xd0
* AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
* AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
* mesh point: 0xb0 0xc0 0xd0
* P2P-client: 0x40 0xd0
* P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
* P2P-device: 0x40 0xd0
software interface modes (can always be added):
* AP/VLAN
* monitor
valid interface combinations:
* #{ managed, WDS, P2P-client } <= 2048, #{ AP, mesh point,
P2P-GO } <= 8, #{ IBSS } <= 1,
total <= 2048, #channels <= 1, STA/AP BI must match
* #{ AP } <= 1,
total <= 1, #channels <= 1, STA/AP BI must match, radar
detect widths: { 20 MHz (no HT), 20 MHz }
HT Capability overrides:
* MCS: ff ff ff ff ff ff ff ff ff ff
* maximum A-MSDU length
* supported channel width
* short GI for 40 MHz
* max A-MPDU length exponent
* min MPDU start spacing
Device supports TX status socket option.
Device supports HT-IBSS.
Device supports low priority scan.
Device supports scan flush.
Device supports AP scan.
--
Matthias May
Software Engineer
Neratec Solutions AG
Postfach 83, CH-8608 Bubikon, Switzerland
Direct: +41 55 253 2074
Office: +41 55 253 2000
Fax: +41 55 253 2070
email: matthias.may@neratec.com
Web: www.neratec.com
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2013-07-09 7:10 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2013-07-08 13:29 [ath9k-devel] AR9580/90 Daniel Wunderlich
2013-07-09 7:10 ` Matthias May
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.