[PATCH] arch_timer: Move delay timer to drivers clocksource

[daniel.lezcano@linaro.org (Daniel Lezcano)]

On 01/17/2014 07:36 PM, Stephen Boyd wrote:
> On 01/17/14 05:40, Prashant Gaikwad wrote:
>>
>> Another requirement:
>>
>> We have 3 timers T1, T2, T3 used as wake events for 3 idle states C1,
>> C2, C3 respectively.
>>
>> Rating of T2 is better than T3. If I register T2 and T3 both as
>> broadcast timers then T3 will not be used. But ...
>>      - T2 is not preserved in C3 idle state.
>>      - T3 resolution is very poor (ms) and can not be used as wake
>> event for C2.
>>
>> Possible solution, register only T3 as broadcast device and use T2 as
>> per-CPU fallback timer.
>
> We have the same situation on MSM. I've been thinking about proposing we
> allow multiple broadcast timers to exist in the system and then have the
> clockevents_notify() caller indicate which C state is being entered. The
> broadcast timers would need to indicate which C state they don't work in
> though.

IMO, there are different solutions:

1. extend the C3STOP to C1STOP, C2STOP, etc ... and pass the idle state 
to the time framework where these flags are checked against. I don't 
like this approach but it is feasible.

2. use the generic power domain. When the power domain is shutdown via 
the cpuidle backend driver, it switches the timer.


-- 
  <http://www.linaro.org/> Linaro.org ? Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog